User manual RYOBI RK43-2 VUE GLOBALE

[. . . ] Connecting the vacuum cleaner to a higher voltage may result in damage to the vacuum cleaner or injury. This appliance has a polarized plug (one blade is wider than the other. If it still does not fit, contact a qualified electrician to install the proper outlet. Check the packaging, vacuum cleaner and accessories for any signs of damage. [. . . ] B Insert the plug into the socket on the inside of the carrying handle. D Press the two release buttons at the sides of the elbow and lift the hose from the socket. Connecting the hand piece and the Electro Telescopic wand ^ Insert a the hand piece into the electro telescopic wand until it clicks into place. ^ To release the hand piece from the telescopic wand press the locking button (see arrow) and pull b the hand piece away from the telescopic wand. 10 Before using the vacuum cleaner Using the Powerbrush Observe the cleaning instructions of the floor manufacturer. The Powerbrush is particularly suitable for cleaning and restoring crushed carpet pile of wall to wall carpeting and floor coverings subject to hard wear, especially in high traffic areas. Do not use the powerbrush on: ­ (SEB 217-3/EB02 only) Floors with a variable or uneven surface. ­ High quality, hand knotted rugs, for example Berber or Persian rugs, as well as extremely long piled area rugs and carpets. Turn the Powerbrush off to vacuum these types of floor coverings and use only suction. Connecting the Powerbrush to the Electro Telescopic wand ^ Insert a the Electro Telescopic wand into the Powerbrush until it clicks into place. ^ To release the parts, press the lock release button and pull the wand up and out b. Be certain to continuously touch this inlay when vacuuming fine dust, flour or sawdust as these materials are more likely to create a static discharge. To further prevent static discharge while vacuuming, pull the vacuum along by the hose with one hand while continuing to hold the hand piece in the other hand. 16 Use Turning the Powerbrush On/Off The Powerbrush is turned on and off separately from the vacuum using the hand piece. 17 Transport and storage Park system (unable to be used with the Powerbrush SEB 228/EB03) The Park system allows you to conveniently park the telescopic wand on the vacuum cleaner during brief pauses. Insert the lower clip on the floor brush into the slot on the end of the vacuum cleaner from above. Transport and storage ^ For easier transportation and storage stand the vacuum cleaner vertically. ^ Insert the parking clip attachment on the floor tool or floor brush into the parking slot from above (does not apply to Powerbrush SEB 228/EB03). ^ To save space, completely collapse the tubes in the telescopic wand. 18 Maintenance and care , Turn off and unplug the vacuum Purchasing new dustbags and filters Original Miele dustbags and filters can be purchased from an authorized Miele vacuum dealer or by visiting the Miele store at http://store. ­ Dustbag ­ Exhaust filter ­ Dust compartment filter Each of these components must be changed periodically to maintain the vacuum cleaner's efficiency. Only use Miele dustbags, filters and accessories with the "Original Miele" logo. [. . . ] Replacing the Air Clean filter Do not use more than one filter at a time. ^ Open the filter frame until it clicks, grasp the clean corner (see arrow) and remove the used filter a. 22 Maintenance and care Exchanging exhaust filters Depending on the model, there may also be an Active HEPA exhaust filter included which can be used instead of the standard Air Clean exhaust filter. In order to use the Active HEPA filter the Air Clean filter and filter frame must be removed. [. . . ]