User manual RYOBI RFT254

[. . . ] It is essential that you read the instructions in this manual before mounting and operating this machine. EN FR Injuries may be caused, or aggravated, by prolonged use of a tool. When using any tool for prolonged periods, ensure you take regular breaks. Subject to technical modifications / Sous réserve de modifications techniques English(Original instructions) Your product has been engineered and manufactured to Ryobi’s high standard for dependability, ease of operation, and operator safety. [. . . ] The safe use of this product requires an understanding of the information on the tool and in this operator’s manual as well as a knowledge of the project you are attempting. 7 mm lines (18 pcs) - Line carrier - Knob (4 pcs) - Bolt (4 pcs) 7 WARNING Be certain all knobs are fully tightened before operating equipment; check them periodically for tightness during use to avoid serious personal injury. iNSTALLING THE PRO CUT STRING HEAD/SHAFT/ GRASS DEFLECTOR ASSEMBLY TO THE TRIMMER POWER HEAD/WHEEL ASSEMBLY See figure 2. WARNING Never install, remove, or adjust any attachment while the engine is running or cutting head is moving. Failure to stop the engine and cutting head can cause serious personal injury. The Pro Cut string head/shaft/grass deflector assembly connects to the trimmer power head/wheel assembly by means of a coupler device. –■ Loosen the knob on the coupler of the power head shaft and remove the end cap from the String head/ shaft/grass deflector assembly. Align the button with the guide recess on the power head coupler and slide the two shafts together. Rotate the string head shaft until the button locks into the positioning hole. English(Original instructions) NOTE: If the button does not release completely in the positioning hole, the shafts are not locked into place. Slightly rotate from side to side until the button is locked into place. If needed, turn the trimmer head which will aid in the insertion of the shaft. –■ Place the lower handlebar into the openings on the trimmer power head/wheel assembly as shown. NOTE: Do not allow throttle cable to become pinched when installing the handlebar. Make sure the throttle cable and throttle trigger are on the right side as shown. NOTE: Do not allow throttle cable to become pinched when installing the handlebar. –■ Align the holes in the clip, the upper handlebar and lower handlebar. –■ Gather two of the pre-cut lengths of trimmer line provided or cut two pieces of trimmer line in 25. –■ Insert the lines into the load slots located on the sides of the string head. Line should be pushed in until approximately 2 cm protrudes from the holes on the top of the string head. –■ Remove old line by pulling it from the holes located on the top of the string head. If head is opened, compression springs could fly out toward operator and result in serious injury. [. . . ] 23 EN GUARANTEE FR GARANTIE In addition to any statutory rights resulting from the purchase, this product is covered by a guarantee as stated below. The guarantee period is 24 months for consumers and commences on the date when the product was purchased. This date has to be documented by an invoice or other proof of purchase. The product is designed and dedicated to consumer and private use only. [. . . ]