User manual RYOBI R152 SCHEMA ELECTRIC

[. . . ] a = Minimum safety distances: KM 400 = 2" (50 mm) KM 402 / 403= 2" (50 mm) KM 408-1 = 2" (50 mm) KM 410 / 411 =10" (250 mm) Deep fryers must not be installed next to gas cooktops. A distance of at least 12" (305 mm) should be maintained between these two appliances. recommended not recommended not allowed 4 IMPORTANT SAFETY INSTRUCTIONS Cooktops should not be installed above a dishwasher, washer, dryer, freezer or refrigerator. The high temperatures radiated downwards from the cooktops could damage these appliances. [. . . ] The high temperatures radiated downwards from the cooktops could damage these appliances. This equipment has not been designed for maritime use or for use in mobile installations such as aircraft or recreational vehicles. However, under certain circumstances it may be possible for an installation in these applications. Please contact the nearest Miele Dealer or the Miele Technical Service Department with specific requirements. Make sure that the power cord to the cooktop does not come into contact with any mechanical parts once the cooktop has been installed. Safety distance above the appliances As a general rule there must be a minimum safety distance of at least 30 inches (760 mm) between the top of the appliance and any cabinet above it, b. The minimum distance of combustible surfaces located above and to the side of the cooktop, c, is 18" (457 mm). If the cabinet manufacturer recommends a different distance, follow that manufacturer's recommendation. Do not allow the spring clamps to "float", they must be securely fastened. The screws are not necessary for granite countertops. 11 Installation Locking the appliance into place Make sure the cooktops are aligned correctly before setting them into the countertop. Once the spring clamps are engaged, a special tool is required to release the cooktop from the clamps. ^ Guide the power cord through the cut out and connect the appliance to the electrical supply. With a hand on each side, above the clamps, a, press the cooktop down, locking it into the spring clamps. Make sure that the cooktop rim lies flat against the countertop on all sides. 12 Installation Important The cooktop must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the cooktop provides a sufficient seal for the countertop. If the cooktop is sealed into position, the countertop or the appliance may be damaged if the cooktop needs to be removed for maintenance or service. 13 Electrical connection , WARNING: Disconnect the appliance from the main power supply before servicing. To reduce the risk of electric shock, make sure that the appliance is properly grounded after installation. [. . . ] If the cooktop is sealed into position, the countertop or the appliance may be damaged if the cooktop needs to be removed for maintenance or service. 13 Electrical connection , WARNING: Disconnect the appliance from the main power supply before servicing. To reduce the risk of electric shock, make sure that the appliance is properly grounded after installation. To guarantee the electrical safety of this appliance; continuity must exist between the appliance and an effective grounding system. [. . . ]