User manual RYOBI POWER KIT: 570W JIGSAW EJS570FK

[. . . ] e) When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. f) If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. [. . . ] Check for misalignment of binding or moving parts, breakage of parts and any other condition that may affect the power tools' operation. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g) Use the power tool, accessories and tool bits etc. , in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. 5) Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö Following this rule will reduce the risk of eye injury. If using an extension lead, ensure that the male and female plug connection is elevated and out of the way of any water contact. ¡ö ¡ö SUGGESTIONS FOR PROPER USE OF THE JIGSAW OPERATION The switch can be maintained in the operating position by using the lock-on button. The lock-on button can be released by pressing the on/off switch once more. ELECTRONIC SPEED REGULATION (Fig. 4) extraction system will work most effectively when the safety guard is in its down position. They must be open at all times for proper motor cooling. POCKET CUTTING Cut at an even rate and take care not to over load the saw. Excessive force on the saw will prevent the pendulum action operating correctly and reduce the cutting efficiency. Together with a centre pin, the rip fence can also be used for cuting circles. The electronic speed control wheel is uesd to programme the required saw speed. In this way the speed can be adapted to fit the material being worked. Number 1 being the slowest speed. PENDULUM STROKE ADJUSTMENT (Fig. 5) SPECIFICATIONS Power input: No load speed: Stoke length: Cutting capacity: 570 W 500-3, 000 min 18 mm Aluminium: 15 mm Steel: 8 mm Wood: 65 mm 0°- 45° 2. 00 kg -1 Together with the electronic speed regulation, the pendulum stroke adjustment helps set the best combination of blade speed and aggressiveness needed to achieve a desired cut rate and fineness. ¡ö When using a knife blade, the pendulum setting should be 0. [. . . ] Pull the base plate backward and set the desired angular adjustment according to the scale or push the base plate forward for fixed locks at 0°, 15°, 30°, 45°. Always replace the allen key in the allen key holder above the base plate immediately after use. (Fig. 7) ¡ö ¡ö ¡ö This power tool normally requires no maintenance, however, lubricating the guide roller from time to time with a drop of oil will extend the life of the roller. [. . . ]