User manual RYOBI POWER KIT: 200W ORBITAL SANDER EOS200FK

[. . . ] The term "power tool" in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. b) Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Unmodified plugs and matching outlets will reduce the risk of electric shock. [. . . ] The correct power tool will do the job better and safer at the rate for which it was designed. b) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. c) Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventative safety measures reduce the risk of starting the power tool accidently. 1 GENERAL POWER TOOL SAFETY WARNINGS ¡ö ¡ö d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Check for misalignment of binding or moving parts, breakage of parts and any other condition that may affect the power tools' operation. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g) Use the power tool, accessories and tool bits etc. , in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. 5) Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. ¡ö Protect your lungs. If using an extension lead, ensure that the male and female plug connection is elevated and out of the way of any water contact. ¡ö ¡ö OPERATION For continuous operation, press the lock-on switch while the trigger is depressed. Any excess pressure will retard the sanding action, giving an uneven finish and cause extra wear to both tool and sanding paper. Never allow sander to stay in one place too long, or excessive material will be removed. [. . . ] Always disconnect the electrical cord from the power source before changing the sandpaper, brushes, or when working on the unit. When the carbon brushes are worn to the standard line, they must be replaced. WARNING: Make sure the workpiece is free of nails and foreign objects which could tear the sanding paper. VARIABLE SPEED CONTROL (Fig. 5) SERVICE Now that you have purchased your tool, should a need ever exist for repair parts or service, simply contact your nearest Ryobi Authorised Service Centre or other qualified service organisation. Be sure to provide all pertinent facts when you call or visit. The variable speed control wheel is used to programme the required sanding speed. [. . . ]