User manual RYOBI MM WS13-125SXEK

[. . . ] This may significantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. Failure to b) Operations such as polishing are not recommended follow the warnings and instructions may result in electric shock, to be performed with this power tool. [. . . ] Always use auxiliary handle, if provided, for maximum control over kickback or torque reaction during start-up. The operator can control torque reactions or kickback forces, if proper precautions are taken. C) Do not position your body in the area where power tool will move if kickback occurs. Kickback will propel the tool in direction opposite to the wheel’s movement at the point of snagging. Corners, sharp edges or bouncing have a tendency to snag the rotating accessory and cause loss of control or kickback. Safety Warnings Specific for Grinding and Abrasive CuttingOff Operations: a) Use only wheel types that are recommended for your power tool and the specific guard designed for the selected wheel. Wheels for which the power tool was not designed cannot be adequately guarded and are unsafe. B) The guard must be securely attached to the power tool and positioned for maximum safety, so the least amount of wheel is exposed towards the operator. The guard helps to protect the operator from broken wheel fragments, accidental contact with wheel and sparks that could ignite clothing. Abrasive cut-off wheels are intended for peripheral grinding, side forces applied to these wheels may cause them to shatter. D) Always use undamaged wheel flanges that are of correct size and shape for your selected wheel. Proper wheel flanges support the wheel thus reducing the possibility of wheel breakage. Flanges for cut-off wheels may be different from grinding wheel flanges. Wheel intended for larger power tool is not suitable for the higher speed of a smaller tool and may burst. Additional Safety Warnings Specific for Abrasive Cutting-Off Operations: GB a) Do not “jam” the cut-off wheel or apply excessive pressure. Kickback is a sudden reaction to a pinched or snagged rotating wheel, backing pad, brush or any other accessory. Overstressing the wheel increases the loading and susceptibility to twisting or ging causes rapid stalling of the rotating accessory which in turn English 15 GB binding of the wheel in the cut and the possibility of kickback or wheel breakage. B) Do not position your body in line with and behind the rotating wheel. When the wheel, at the point of operation, is moving away from your body, the possible kickback may propel the spinning wheel and the power tool directly at you. C) When wheel is binding or when interrupting a cut for any reason, switch off the power tool and hold the power tool motionless until the wheel comes to a complete stop. Never attempt to remove the cut-off wheel from the cut while the wheel is in motion otherwise kickback may occur. Investigate and take corrective action to eliminate the cause of wheel binding. [. . . ] Flenser for kappeskiver kan være annerledes enn flenser for andre slipeskiver. Ytterligere spesielle advarsler for kappesliping a) Unngå blokkering av kappeskiven eller for sterkt presstrykk. E) Støtt plater eller store arbeidsstykker for å redusere risikoen for tilbakeslag fra en fastklemt kappeskive. NÄTANSLUTNING Får endast anslutas till 1-fas växelström och till den spänning som anges på dataskylten. [. . . ]