User manual RYOBI HTK2360MT

[. . . ] Do not cut against hard objects, this could cause injury or damage the trimmer. As equipment user, you are responsible for third parties in the working area. While operating the tool, always hold it firmly with both hands by the two handles and ensure a firm footing, especially if steps or ladders are used. Make sure you hold the tool firmly with both handles and that you are well balanced with your weight evenly distributed on both feet. [. . . ] Never connect the product to an AC voltage that differs from this voltage. If the power cord or extension cable becomes damaged during use, disconnect the cord from the supply immediately. Avoid bodily contact with earthed parts such as metal pipes, radiators, cooking ranges, refrigerators and the like. Electrical power should be supplied via a Residual Current Device (RCD) with a tripping current of not more than 30 mA. check the product regularly to make sure that it will operate properly and perform the intended function. Any part that is damaged should be properly repaired or replaced by an Authorised Ryobi Service Centre. Wipe down housing with a damp cloth only, then dry fully and make sure there is no debris remaining in the blade or working parts. After each use, carefully clean the blade, rub over with an oily cloth or treat with an environmentally friendly lubricant. WARNING Before carrying out any maintenance operations, cut off the electric power supply by disconnecting the plug from the mains. Service on this product must be performed by qualified repair personnel only. service or maintenance performed by unqualified personnel could result in injury to the user and/or damage to the product. RHT-600R Rated voltage Power rating Rated no-load speed Cutting capacity Blade length Braking time Weight (without cable) LpA (noise) LwA (sounding power) Vibration level 220-240 V~/ 50 Hz 600 W 1500 min-1 27 mm 550 mm <1 s 4. Connect the tool plug to an approved extension lead (if required) and protect the plug connection with the pull-relief (5) (Fig. Once plugged to electric supply, the live tool indicator (9) shows a blue light, which means this tool is ready for use. In the desired end position, release the lock button (8) back into place to secure the handle position. Please bear in mind that the lock button (8) can only be pulled back when the On/Off switch (4) is not activated. Make sure that the lock button fully engages into the housing again after repositioning the turning handle. This system prevents starting the tool inadvertently and will only allow operation while holding the tool with both hands. To switch on: Press the bow grip On/Off switch (3) and the On/Off switch at rotational handle (4) with both hands at the same time. Note: The sparking (flashing) resulting in the area of the vent slits / top of the main enclosure is normal and will not damage the tool. When you stop your equipment, be sure that the cutting system comes to complete stop before proceeding further. Note: This tool cannot be started if the lock switch (8) is pulled backward and/or the rotational handle (4) is being turned. [. . . ] Release the On/Off switch (4), pull the lock button (8) backward (Fig. The rotational handle is now unlocked and can be turned to the desired position (Fig. Waste electrical products should not be disposed of together with household waste. För att underlätta arbetet är häcksaxen utrustad med ett bakre vändbart handtag som kan placeras i 5 olika lägen (höger, 45° till höger eller till vänster eller 90° till höger eller till vänster). [. . . ]