User manual RYOBI HT716R-HT718R-HT722R

[. . . ] Use of a cord suitable for outdoor use reduces the risk of electric shock. If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply, the tripping current of 30mA or less. The correct power tool will do the job better and safer at the rate for which it was designed. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. [. . . ] Use of sturdy gloves, non-skid footwear, and safety glasses is recommended; Stop the engine or disconnect from mains before: -Cleaning or when clearing a blockage; -Checking, maintenance or working on the machine; -When adjusting the working position of the cutting device. N Where the hedge trimmer is provided with adjustments to the angle of the cutting device and / or the length of the handle shaft never hold the cutter blades when making adjustments to the working position of the cutting device. Always ensure that the cutting device is correctly located in a designated working position before starting the engine or plugging the machine in to the mains; While operating the machine be always sure of a safe and secure operating position especially when using steps or a ladder; Do not attempt to repair the machine unless you are qualified to do so; 10 Some of the following symbols may be used on this product. Proper interpretation of these symbols will allow you to operate the product better and safer. SYMBOL V A Hz W hrs Volts Amperes Hertz Watt Hours Class II Construction Wet Conditions Alert NAME Voltage Current Frequency (cycles per second) Power Time Double-insulated construction Do not expose to rain or use in damp locations. To reduce the risk of injury, user must read and understand operator's manual before using this product. Wear non-slip, heavy-duty protective gloves when handling the pole saw and the blade. Do not install or use any type of blade on a product displaying this symbol. Electrical hazard , at least 15m away from the overhead lines The following signal words and meanings are intended to explain the levels of risk associated with this product. SYMBOL SIGNAL MEANING Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. Push poles towards each other to shorten the pole or pull away from each other to lengthen the pole. NOTE: Extend the telescopic pole only to the length required to reach the hedges being trimmed. Do not attempt to use the pole hedge trimmer at a length which does not allow you to achieve proper footing and balance at all times. Never hold shrubs with one hand and operate hedge trimmer with the other. Remove all objects such as cords, lights, wire, or loose string which can become entangled in the cutting blade and create a risk of serious personal injury. When operating the hedge trimmer, keep the extension cord behind the trimmer. If blades do become jammed, stop the motor, allow the blades to stop, and disconnect the plug from the power source before attempting to remove the obstruction. trim the side of a hedge so that it will be slightly narrower at the top. More of the hedge will be exposed when shaped this way, and it will be more uniform. [. . . ] În timpul operrii mainii asigurai-v mereu c avei o poziie de operare sigur i fix în special când folosii trepte sau o scar. TTI warrants this outdoor product to be free of defects in material or workmanship for 24 months from the date of purchase by the original purchaser, subject to the limitations below. This warranty is only applicable where the product is used for personal and non-commercial purposes. This warranty does not cover damage or liability caused by / due to misuse, abuse, accidental or intentional acts by user, improper handling, unreasonable use, negligence, failure by end user to follow operating procedures outlined in the user's manual, attempted repair by non-qualified professional, unauthorized repair, modification, or use of accessories and/or attachments not specifically recommended by authorized party. [. . . ]