User manual RYOBI ERH-600V

[. . . ] Vennligst les instruksjonene i denne bruksanvisningen før du monterer og tar i bruk maskinen. On ehdottoman välttämätöntä lukea tässä käyttöohjeessa annetut ohjeet ennen asennusta ja käyttöönottoa. Feltétlenül fontos, hogy a jelen használati útmutatóban foglalt elírásokat az összeszerelés és az üzembe helyezés ellt elolvassa ! [. . . ] Before further use of the tool, a guard or other part that is damaged should be carefully checked to ensure that it will operate properly and perform its intended function. Check the mounting and any other condition that may affect tool operation. A guard or other part that is damaged should be properly repaired or replaced by an authorised service centre unless otherwise indicated elsewhere in this instructions manual. Have defective switches replaced by an Authorised Ryobi Service Centre. Warning The use of any accessory or attachment other than those recommended in this user's manual may present a risk of personal injury. Have your tools repaired by a qualified technician. Have it repaired by a qualified technician in an Authorised Ryobi Service Centre. Wherever there are facilities for fitting a dust extraction system, make sure it is properly connected and correctly used. Noise level (or sound pressure level) in the work area can exceed 85 dB(A). In this case, operators should take appropriate measures to ensure sound insulation and wear ear protectors. 5 English DESCRIPTION (FIG. Fastening sleeve Variable switch with reverse action Lock-on button Auxiliary handle Depth stop Mode selector ITEMS SUPPLIED Case Hammer drill Depth stop Auxiliary handle Make sure of your footing on ladders and scaffolding when drilling freehand. Use a line detector to locate concealed electric, water or gas lines in walls. Always pull the plug out of the socket before cleaning your tool or changing accessories. Important It is imperative to follow all national safety regulations concerning installation, operation and maintenance of the tool. PRODUCT SPECIFICATIONS Voltage Power consumption No Load Speed No load speed in hammer mode Maximum drilling capacity: - steel - concrete / stone Tool Attachment Weight Vibration level Insulation class 230 V / 110 V 50 Hz AC only 600 W 0 - 850 min-1 0 - 4, 400 min-1 10 mm 20 mm SDS-Plus 2. 8 kg 5. 0 m/s2 II Noise and vibration values measured according to EN 50144. SAFETY PRECAUTIONS Important To protect yourself from the risk of electric shock, injury and fire when using an electric tool, it is imperative to take the following basic safety precautions. Before you use your tool, read these instructions carefully and make sure that you understand them thoroughly. Make sure that the voltage (Volts) used corresponds to the voltage marked on the tool's rating plate. [. . . ] The rotational direction switch (2) has two positions: REMOVING THE BIT FROM THE SDS-PLUS SYSTEM (FIG. 3) Pull back the fastening sleeve (A) and remove the bit. SWITCHING ON/OFF Clockwise rotation: Set the rotational direction switch (2) to the right position. Anti-clockwise rotation: Set the rotational direction switch (2) to the left position. [. . . ]