User manual RYOBI EMS180RV

[. . . ] DUST COLLECTION BOX The dust collection box attaches to the sander and keeps dust to a minimum. VARIABLE SPEED SPECIFIC SAFETY INSTRUCTIONS FOR SANDERS Ŷ Ŷ Ŷ Always wear safety goggles and a dust mask when sanding, especially sanding over-head. Extra paper extending beyond the sanding pad can also cause serious lacerations. To connect dust collection box, insert the adapter of dust box to the dust-collection opening on the rear end of the sander. [. . . ] Always empty and clean the dust collection box thoroughly upon completion of a sanding operation and before placing the sander in storage. Place the sander on the workpiece so that all of the sanding disc surface is in contact with the workpiece. WARNING Collected sanding dust from sanding surface coatings such as polyurethanes, linseed oil, etc. , can self-ignite in your sander dust collection box or elsewhere and cause ¿re. To reduce the risk of ¿re always empty your dust collection box frequently (10-15 minutes) while sanding and never store or leave a sander without totally emptying its dust collection box. CAUTION Avoid damaging the motor from overheating; be careful not to let your hand cover the air vents. NOTE: Hold the sander in front and away from you, keeping it clear of the workpiece. Start sander and let the motor build to its maximum speed, then gradually lower the sander onto the workpiece. Move the sander slowly across the workpiece using small circular motions. The weight of the unit supplies adequate pressure, so let the sanding disc and sander do the work. Applying additional pressure only slows the motor, rapidly wears sanding disc and greatly reduces sander speed. Excessive pressure will overload the motor causing possible damage from motor overheating and can result in inferior work. Any ¿nish or resin on wood may soften from the frictional heat. Do not allow sanding on one spot too long as the sander’s rapid action may remove too much material, making the surface uneven. If this occurs, turn sander off and wait until sanding disc comes to a complete stop, then remove it from workpiece. Remove your hand from vent area, remove sanding disc, then with your hand removed from vent area, turn sander on and run it free without a load to cool motor. Ŷ For detail sanding such as corners and crevices, use the tip of the sanding pad with small back and forth motions. WARNING Failure to unplug the tool could result in accidental starting causing possible serious injury. NOTE: For a more thorough cleaning of the dust collection box, remove dust collection box from frame and shake out dust. Replace dust collection box over frame then install dust collection box assembly on sander. When ¿tting the new base, place the base up to the sander and insert the ¿rst screw (do not tighten). Align holes in hook and loop type sanding disc with holes in pad, then carefully press fuzzy side of sanding disc against pad as tightly as possible. [. . . ] An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may signiÀcantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Contudo, se a ferramenta for usada para aplicações diferentes, com acessórios diferentes ou não for devidamente mantida, a emissão de vibrações pode diferir. [. . . ]