User manual RYOBI EJ700L

[. . . ] A hazard may exist if you deliberately stare into the beam, please observe all safety rules as follows: „ The laser shall be used and maintained in accordance with the manufacturer’s instructions. „ Never aim the beam at any person or an object other than the work piece. „ The laser beam shall not be deliberately aimed at personnel and shall be prevented from being directed towards the eye of a person for longer than 0. „ Always ensure the laser beam is aimed at a sturdy work piece without reflective surfaces such as wood or rough coated surfaces are acceptable. [. . . ] WARNING Your saw should never be connected to power supply when you are assembling parts, making adjustments, installing or removing blades or when not in use. Disconnecting your saw will prevent accidental starting which could cause serious injury. Rest the front of the saw base on the workpiece and align cutting edge of the blade with the line on your workpiece. Make sure the power cord is out of the way of saw blade and not in the line of cut. Apply downward pressure to keep the saw steady and only enough forward pressure to keep the blade cutting. Bevel cutting angles may be adjusted from 0° to 45° right or left. Angles for cuts from 0° to 45° in 15° increments are marked on a scale on both the left and right side of the base. The use of a protractor is recommended when accurate cuts are required. „ Slide base forward slightly to release the base from the tab on the motor housing. „ Align the mark on the base of the desired angle with the edge of the motor housing. „ Once the desired angle is reached, slide the base back until the tab on the motor housing aligns with the appropriate notch on the rear of the base. This feature is adjustable and provides faster and more ef¿cient cutting. With orbital motion the blade cuts through your work in the upstroke but does not drag across your work in the downstroke. „ Higher settings (H) should be used when fast cutting in soft material. „ Lower (L) settings should be used when cutting materials with more resistance. A straight cut can be made by clamping a piece of wood or straightedge to the workpiece and guiding the edge of your saw against it. Make the cut from one direction only, do not cut halfway to complete the cut from the opposite end. 3 WARNING To avoid loss of control, broken blades, or damage to the material being cut, always use extreme caution when making plunge cuts. „ Tilt your saw forward so that it rests on the front edge of the base and blade will not come in contact with the workpiece when the saw is turned on. GB FR DE ES IT NL PT DK SE FI NO RU PL CZ HU RO LV LT EE HR SI SK GR TR English „ Make sure the blade is inside the area to be cut. „ Start your saw by using high speed and slowly lower the blade into the workpiece until the blade cuts through the wood. „ Continue lowering the blade into the workpiece until the base rests flat on the work surface, then move the saw forward to complete the cut. [. . . ] An estimation of the level of exposure to vibration should also take into account the times when the tool is switched off or when it is running but not actually doing the job. This may signiÀcantly reduce the exposure level over the total working period. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Contudo, se a ferramenta for usada para aplicações diferentes, com acessórios diferentes ou não for devidamente mantida, a emissão de vibrações pode diferir. [. . . ]