User manual RYOBI EBS800

[. . . ] Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. This enables better control of the power tool in unexpected situations. [. . . ] The correct power tool will do the job better and safer at the rate for which it was designed. Any power tool that can not be controlled with the switch is dangerous and must be repaired. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. Use the power tool, accessories and tool bits etc. , ■ ■ ■ ■ ■ ■ ■ ■ ■ PERSONAL SAFETY ■ Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment ■ ■ 1 Safety in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from intended could result in a hazardous situation. SERVICE ■ Have your power tool serviced by a qualified repair person using only identical replacement parts. Removing rust from and sanding steel surfaces. MAINTENANCE WARNING The tool should never be connected to a power supply when you are assembling parts, making adjustments, cleaning, performing maintenance, or when the tool is not in use. Disconnecting the tool will prevent accidental starting that could cause serious injury. SPECIAL SAFETY RULES ■ This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the product by a person responsible for their safety. Children should be supervised to ensure that they do not play with the product. Visitors should wear safety glasses and be kept as a safe distance from work area. It is recommended that this tool always be supplied via a residual current device with a rated residual current of 30mA or less. Hold power tool by insulated gripping surfaces, because the belt may contact its own cord. Cutting a “live” wire may make exposed metal parts of the power tool “live” and could give the operator an electric shock. Always wear safety goggles and a dust mask when sanding, especially sanding overhead. [. . . ] One of the ways to clean sanding belt is to rub the sheets with a hard rubber block. You can also use the clean rubber sole of a shoe. ICONS IN THIS MANUAL Safety WARNING Always remove the sanding belt from sander before cleaning. Failure to do so could cause serious personal injury. Unpacking Getting started ENVIRONMENTAL PROTECTION Recycle raw materials instead of disposing of as waste. The machine, accessories and packaging should be sorted for environmental-friendly recycling. Operation Safety alert SYMBOL Safety Alert V Hz W no min‫¹־‬ Volts Hertz Alternating current Watts No-load speed Revolutions or reciprocations per minute Conformity Double insulation Unplug Plug in Lock Unlock Information Please read the instructions carefully before starting the product. [. . . ]