User manual RYOBI EBS-7076

[. . . ] When not in use, tools should be stored in a dry, high or locked up place, out of reach of childen. Do not force small tools or attachments to do the job of a heavy duty tool. [. . . ] Do not place the tool on a surface while the belt is still moving since belt rotation will cause it to move, and may result in the tool being damaged or personal injury. Clamp the work piece if it does not remain stationary due to its own weight. Although the dust bag has a substantial capacity, it should be emptied frequently. Input Power No load speed Belt size Net weight Opening the zipper of the dust bag allows complete cleaning. CAUTION When sanding metal, the dust bag should not be used, because of the risk of fire from flying sparks. Place the tool on its side and lift the lever (3) to retract the front roller and release the belt tension (Fig. If the belt tension is not released after lifting the lever, loosen the adjustment knob (9) (Fig. NOTE: Be sure that the arrow inside of the belt is pointing in the same direction as that of the tool. Be sure to check the nameplate on the product, because the voltage is subject to change depending on the area in which the product is to be used. Front handle Sanding belt Tension release lever Rear handle Dust bag Dust point 7. In this case, sound insulation and hearing protection measure must be taken by the operator. Turn the tool upside down and hold if firmly with one hand, then start the tool and observe the traking of the sanding belt. [. . . ] In the event of malfunction during the warranty period, please take the NON-DISMANTLED product, along with the proof of purchase, to your retailer or nearest Authorised Ryobi Service Centre. This warranty in no way affects your legal rights concerning defective products. [. . . ]