User manual RYOBI EAG-8011

[. . . ] Never touch the blade, grinding wheel or other moving parts during use. Never start a tool when its rotating component is in contact with the work piece. [. . . ] Inspect the grinding wheel before use to ensure that it is not chipped or cracked. Chips or cracks can cause the wheels to shatter, resulting in possible serious injury. Ensure that the grinding wheel is correctly mounted and tightened before use and run the tool at no-load speed for 30 seconds in a safe position. Stop immediately if there is considerable vibration or if other defects are detected. Grinding wheel Voltage* Input Spindle thread No load speed Overall length Net weight EAG-8011 115 mm (4-1/2") 230 V ~ 50 Hz 800 W M14 11, 000 min-1 310 mm 2. * Be sure to check the nameplate on the product, because the voltage is subject to change depending on the area in which the product is to be used. 14 x 125 x 11, 000 / 1, 000 4, 320: Circumferential speed of grinding wheel 125: Wheel diameter 11, 000: No load speed of grinder Handle Spindle lock button Switch Disc flange Clamp nut Spindle shaft Wrench Diamond blade (optional) Wheel guard lock lever Live tool indicator WARNING Check carefully whether or not there are cracks in the wheel. Release the wheel guard lock lever (11) then turning the tool-less wheel guard (2) to the desired position. Turning axie is 90° on either side; otherwise the guard can't be locked. In this case, sound insulation and hearing protection measures must be taken by the operator. The key to efficient operating is controlling the pressure and surface contact between the disc and work piece. Flat surfaces are ground at an acute angle, usually 10 to 20 degrees with the work piece. [. . . ] In the event of malfunction during the warranty period, please take the NON-DISMANTLED product, along with the proof of purchase, to your retailer or nearest Authorised Ryobi Service Centre. This warranty in no way affects your legal rights concerning defective products. [. . . ]