User manual RYOBI CML-180

[. . . ] Do not operate any appliance with a damaged cord or plug, after the appliance malfunctions or has been damaged in any manner. Return the appliance to the nearest authorized service facility for service. Do not connect the appliance to the electrical supply with an extension cord. Extension cords do not guarantee the required safety of the appliance, e. g danger of overheating. [. . . ] Children climbing on the appliance to reach these items could be seriously injured. Be aware of loose-fitting or hanging garments while using the warming drawer. Due to the high temperatures radiated, objects left near the appliance could be damaged. When using kitchen appliances near the warming drawer, make certain that the power cords do not come in contact with or get caught in the drawer. Do not install outdoors. 7 Guide to the warming drawer a Timer b Temperature selector c Humidity control d Non-slip mat e Rack f Drawer 8 Guide to the controls The warming drawer is operated by the timer, the temperature selector, and the humidity control. Once the warming drawer begins to heat the circulation fan will turn on to evenly heat the drawer. When the selected temperature is reached, the heat and the fan will shut off to prevent food from drying out. If the temperature drops below the selected temperature, the heat will turn back on. Timer The timer activates the heating elements and circulation fan. A time setting of 1 - 4 hours or "Continuous" can be selected. ­ To set a limited time: Turn the timer clockwise from "0" to the desired time (up to 4 hours. ) ­ To set an unlimited time: Turn the timer counterclockwise from "0" to "Continuous". The knob can not be turned past "4 h" to "Continuous". ­ The "Continuous" setting will warm the drawer until the knob is turned to "0". ^ Clean all surfaces of the drawer and the non-slip mat with a solution of warm water and liquid dish soap. ^ Replace the drawer in reverse order. 18 Frequently asked questions , Repairs should only be carried out by a qualified and trained person in accordance with local and national safety regulations. Some minor problems can be fixed without a service call. What if the drawer does not heat?Check the temperature setting and make sure the food is not too close to the heating element. Turn the timer to a time and/or temperature setting. 19 Frequently asked questions What if the drawer cannot be closed properly?­ Check if the hooks on the underside of the drawer, on the left and right sides, are in the correct position. If a hook has slipped off the track, push it towards the rear of the drawer and up until it clicks into place. 20 Technical Service In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department at the address on the back of this booklet. When contacting Technical Service please quote the serial number and model of the warming drawer. Adhere data plate sticker below. MieleCare (only USA) MieleCare, our Extended Service Contract program, gives you the assurance of knowing that your appliance investment is covered by 5 years of worry free ownership. MieleCare is the only Extended Service Contract in the industry that guarantees repairs by a Miele Authorized Service Provider using genuine Miele parts. Only genuine Miele parts installed by factory trained professionals can guarantee the safety, reliability, and longevity of your Miele appliance. [. . . ] ­ The warming drawer should be level to prevent the drawer from sliding open or closing on its own. If necessary install a shelf within the cabinetry to support the drawer. Steam from the vents can damage the cabinetry surrounding the warming drawer. Solo Installation: A minimum gap of 2" (5 cm) must be present between the upper edge of the warming drawer and the cabinetry. [. . . ]