User manual RYOBI CHD1202

[. . . ] 3) PERSONAL SAFETY a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. [. . . ] That pins on plug of extension cord are the same number, size and shape as those of plug on charger. Do not disassemble charger; take it to a qualified serviceman when service or repair is required. To reduce risk of electric shock, unplug the charger from outlet before attempting any maintenance or cleaning. Refer to them frequently and use them to instruct others who may use this unit. Model Voltage Chuck Switch No load speed(drill mode): - Lo speed - Hi speed Max. To reduce risk of injury, charge only nickel-cadmium type rechargeable batteries. Other types of batteries may burst, causing personal injury and damage. Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injuries to person. To reduce risk of damage to charger body and cord, pull by charger plug rather than cord when disconnecting charger. Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charger. When your battery pack becomes fully charged, the red light will turn off and the green light will turn on. After normal usage, 1 hour of charge time is required to be fully charged. A minimum charge time of 1 to 1-1/2 hours is required to recharge a completely discharged tool. It will work best at temperatures above 10°C and below 38°C IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES When using your tool continuously, the batteries in your battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. Lock switch trigger on your drill by placing the direction of rotation selector in center position. Make sure the latches on battery pack snap in place and battery pack is secured in drill before beginning operation. CHARGING YOUR BATTERY PACK The battery pack for your tool has been shipped in a low charge condition to prevent possible problems. [. . . ] The chuck body could slip in your hand, or your hand could slip and come in contact with the rotating drill bit. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. WARNING Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc. [. . . ]