User manual RYOBI BTS20

[. . . ] (254 mm) TABLE SAW BTS20 - Your new Table Saw has been engineered and manufactured to Ryobi's high standards for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator's manual. Thank you for buying a Ryobi Table Saw. SAVE THIS MANUAL FOR FUTURE REFERENCE + TABLE OF CONTENTS Product Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Once the leg stand is released from the table saw base, ease the legs of the leg stand toward the floor. Keeping your left hand clear of the leg stand, pull the leg stand up until it locks into place. With your left hand firmly on the table tilt handle, grasp the grip with your right hand. Push the leg stand towards the ground with your right hand and pull in the same direction with your left hand until the table saw is in an upright position. Note: You can also refer to the blue label on the top of the table saw for tear-down procedures. Standing to the side of the table saw, grasp the table tilt handle with your left hand. Tilt the table saw to the your left and grab the grip with your right hand. With your right hand on the grip, use your left hand to release the leg stand latch. Once the leg stand is released from the table saw base, ease the legs of the leg stand toward the floor. Place your right hand palm up near the bumper and lift the lower leg of the leg stand up until it locks into place. 11 Page 16 ASSEMBLY TO INSTALL RIP FENCE See Figure 12. To install the rip fence, place the rear lip on the rear rail and pull slightly toward the front of the unit. Swing the locking handle down to automatically align and secure the fence. RIP FENCE REMOVING/REPLACING THE THROAT PLATE See Figure 13. WARNING: Make sure the switch is off and the plug is out of the outlet. Failure to do so could result in accidental starting, resulting in serious personal injury. FRONT RAIL WARNING: Drop blade below saw table when reinstalling the throat plate. To remove the throat plate, first remove the screw holding the throat plate with a phillips screwdriver. With a finger in the finger hole, lift the front end of the throat plate. To reinstall the throat plate, drop blade below saw table and place throat plate in the opening. Push throat plate toward the rear of saw base to engage the spring clip. 13 Page 17 ASSEMBLY BLADE AND GUARD ASSEMBLY WARNING: Do not connect to power supply until assembly is complete. Failure to comply could result in accidental starting and possible serious injury. SMALL HEX WRENCH TO CHECK SAW BLADE INSTALLATION To check the saw blade, first remove the screw holding the throat plate in place. [. . . ] Turn the blade adjusting handle until the bottom of the blade has moved completely to the left side of the slot. If the blade is not an exact 45°, loosen the nuts on the stop bolt inside the cabinet, position the blade, adjust the stop bolt, then retighten lock nut. Make a test cut. - + BEVEL LOCKING LEVER BEVEL INDICATOR BEVEL HANDLE NUTS TO CHECK THE ALIGNMENT OF THE RIP FENCE TO THE BLADE See Figure 41. STOP BOLT WARNING: Before performing any adjustment, make sure the tool is unplugged from the power supply and the switch is in the off ( ) position. Place a framing square beside the blade and move the rip fence up to the square. [. . . ]