User manual RYOBI AK70023

[. . . ] OPERATOR'S MANUAL Trimmer FRS250 Your new trimmer has been engineered and manufactured to AL-KO's high standard for dependability, ease of operation and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator's manual. Thank you for buying an AL-KO trimmer. SAVE THIS MANUAL FOR FUTURE REFERENCE TABLE OF CONTENTS Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 3 Symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 5 Technical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Tighten Securely. GRASS DEFLECTOR BOLT FLAT WASHER LOCK WASHER WING NUT Fig. Install the front handle onto the top side of the drive shaft housing and move it to a comfortable position. Move at least 9 m (30 ft) from refuelling site before starting engine. Do not smoke! 1 Litre 2 Litres 3 Litres 4 Litres 5 Litres + + + + + 20 40 60 80 100 ml ml ml ml ml = = = = = } 50:1 OPERATING THE TRIMMER Hold the trimmer with the right hand on the rear handle and the left hand on the front handle. Trimmer should be held at a comfortable position with the rear handle about hip height. This will prevent grass from wrapping round the drive shaft housing and string head, which may cause damage from overheating. If grass becomes wrapped round the string head, stop the engine, disconnect the sparking plug wire, and remove the grass. Prolonged cutting at partial throttle will result in oil dripping from the silencer. FILLING THE TANK 1. Loosen fuel cap slowly to release pressure and to keep fuel from escaping round the cap. NOTE: It is normal for smoke to be emitted from a new engine during and after first use. 5 9 GB OPERATION ADVANCING THE STRING ADVANCING STRING USING THE EZ LINETM TAP ADVANCE SYSTEM String advance is controlled by tapping string head on grass while running engine at full throttle. NOTE: If the string is worn too short you may not be able to advance the string by tapping it on the ground. ADVANCING THE STRING MANUALLY Push the spool retainer down while pulling on string(s) to manually advance the string. Keep the trimmer tilted towards the area being cut; this is the best cutting area. Use the tip of string to do the cutting; do not force string head into uncut grass. Tree bark, wood mouldings, cladding and fence posts can easily be damaged by the string. This trimmer is equipped with a line trimming cut-off blade on the grass deflector. For best cutting, advance string until it is trimmed to length by the cut-off blade. Advance string whenever you hear the engine running faster than normal. This will maintain best performance and keep string long enough to advance properly. GB 10 OPERATION STARTING AND STOPPING See Figures 8 and 9. IGNITION SWITCH I = ON TO RUN O = OFF TO STOP WARNING Never start or run the engine inside a closed or poorly ventilated area; breathing exhaust fumes can kill. NOTE: Unit is equipped with a positive on-off switch; make sure switch is in the "I" (RUN) position before starting the unit. [. . . ] If "L" low needle can not be turned anticlockwise, do not force plastic limiter caps. If "H" high needle can not be turned anticlockwise, do not force plastic limiter caps. Refer to "Replacing and Cleaning the Air Filter " earlier in this manual. Pull strings while alternately pressing down on and releasing spool retainer. [. . . ]