User manual RYOBI 960R-SERIALS411088141-THRU-

[. . . ] When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. n If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of electric shock. the influence of drugs, alcohol or medication. [. . . ] Spade Bit (mm) Weight - not incl. battery pack (KG) MODEL BATTERY PACK (not included) BPL-1820 BPL-1815 ABP1801 960R-SERIALS411088141-THRU- BATTERY PACK (not included) ABP1801 18 V 2-13 Variable speed 0 - 440 min-1 0 - 1600 min-1 24 Positions 37. 5 32 1. 28 CHARGER (not included) BCL-1800 BCS618 CHARGER (not included) ACR-180 BATTERY TOOL USE AND CARE Recharge only with the charger specified by the manufacturer. A charger that is suitable for one type of battery pack may create a risk of fire when used with another battery pack. When battery pack is not in use, keep it away from other metal objects, like paper clips, coins, keys, nails, screws, or other small metal objects that can make a connection from one terminal to another. Under abusive conditions, liquid may be ejected from the battery; avoid contact. SERVICE Have your power tool serviced by a qualified repair person using only identical replacement parts. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. OPERATION WARNING Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING Always wear safety goggles or safety glasses with side shields when operating products. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. WARNING Do not use any attachments or accessories not recommended by the manufacturer of this product. NOTE: The drill will not run unless the direction of rotation selector is pushed fully to the left or right. Running at low speeds under constant usage may cause the drill to become overheated. If this occurs, cool the drill by running it without a load and at full speed. Place the direction of rotation selector in the center position. Make sure the latches on each side of the battery pack snap in place and that battery pack is secured in the product before beginning operation. TO REMOVE BATTERY PACK Depress the latches on each side of the battery pack. Remove the battery pack from the drill. 3 English OPERATION KEYLESS CHUCK See Figure 4. The drill has a keyless chuck to tighten or release drill bits in the chuck jaws. The arrows on the chuck indicate which direction to rotate the chuck body in order to LOCK (tighten) or UNLOCK (release) the drill bit. When not in use, bits provided with the drill can be placed in the storage area located on the base of the drill. Lock the switch trigger by placing the direction of rotation selector in the center position. Open or close the chuck jaws to a point where the opening is slightly larger than the bit size you intend to use. Also, raise the front of the drill slightly to keep the bit from falling out of the chuck jaws. [. . . ] When drilling through holes, place a block of wood behind the workpiece to prevent ragged or splintered edges on the back side of the hole. When drilling large holes in wood with spade bit, the Max admitted bit size is 32mm. METAL DRILLING For maximum performance, use high speed steel bits for metal or steel drilling. Begin drilling at a very low speed to prevent the bit from slipping off the starting point. [. . . ]