User manual RYOBI 767RJ-767R-41CD767G034-41CD76JG034-41DD76JG034

[. . . ] Disconnect the plug from the power source before making any adjustments, changing accessories, or storing the power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. [. . . ] A moment of inattention while operating power tools may result in serious personal injury. Safety equipment such as dusk mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. WARNING: Page 2 RULES FOR SAFE OPERATION When battery pack is not in use, keep it away from other metal objects like paper clips, coins, keys, nails, screws or other small metal objects that can make a connection from one terminal to another. Under abusive conditions, liquid may be ejected from the battery, avoid contact. SERVICE Have your power tool serviced by an authorised service centre using only identical replacement parts. MAINTENANCE Your power tool requires no additional lubrication or maintenace. If you see some sparks flashing in the ventilation slots, this is normal and will not damage your power tool. WORKING HINTS FOR YOUR DRILL If your power tool becomes too hot, set the speed to maximum and run no load for 2-3 minutes to cool the motor. Where possible use a pilot hole before drilling a large diameter hole. OPERATION CONTENTS OF BOX 14. 4V/18. 0V cordless hammer drill, 2 double-ended bits, 2 battery packs, charger, auxiliary handle. 1) The battery packs for this tool have been shipped in a low charge condition to prevent possible problems. Note: Batteries will not reach full charge the first time they are charged. when the selector is in the centre position, the switch trigger is locked. VARIABLE SPEED This tool has a variable speed switch that delivers higher speed and torque with increased trigger pressure. 4) The drill has a two-speed gear train designed for drilling or driving at LO (1) or HI (2) speeds. A slide switch is located on top of the drill to select either LO (1) or HI (2) speed. When using the drill in the LO (1) speed range, the speed will decrease and the drill will have greater power and torque. When using the drill in the HI (2) speed range, the speed will increase and the drill will have less power and torque. 5) Lock the switch trigger by placing the direction of rotation selector in the central position. Rotate the chuck sleeve to open or close the chuck jaws to a point where the opening is slightly larger than the bit size intended for use. Tighten the chuck jaws on the drill bit by grasping the drill with one hand, while rotating the chuck sleeve with the other hand. To loosen the bit, grasp and hold the drill with one hand, while rotating the chuck sleeve with the other hand. The torque is greater when the torque adjustment ring is set on a higher setting. [. . . ] Use clean cloths to remove dirt, dust, oil, grease, etc. Do not attempt to modify this tool or create accessories not recommended for use with this tool. in a hazardous condition leading to possible serious personal injury. WARNING: Do not at any time let brake fluids, gasoline, petroleumbased products, penetrating oils, etc. Abusive practices can damage tool as well as workpiece. WARNING: Page 5 he Company or its authorised agent. come necessary during the warranty should contact the RYOBI HELPLINE contact the retailer from whom the ased. [. . . ]