User manual RYOBI 764R-SERIALS-103036646-THRU-203096320

[. . . ] Never use brake fluids, gasoline, petroleum based products, or any strong solvents to clean your tool. Before further use of the tool, a guard or any other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or any other part that is damaged should be properly repaired or replaced by an authorised service centre. [. . . ] Visitors should wear safety glasses and be kept a safe and operator dependability, ease of operation, distance from worksafety. SAVE THESE INSTRUCTIONS rugged, trouble freecontact tool or extension cord. 6. When not in use, tools should be stored CAUTION: Carefully read through this in a dry and high or locked-up place, out of reach of children. do the job better and safer at It will the rate at which it was designed. FOR FUTURE REFERENCE entire owner's manual before using your Due to continued product refinement policy, product features 8. Pay close attention to the small tool or attachment to do the job of a heavy duty tool. Don't use tool for purpose not If you use your impact drill properly and only for what it isand specifications can and will safe, intended, you will enjoy years of intended. current features and specifications They You caught for buying Rubber tools. Thankcan be againin moving parts. Ryobi gloves and nonskid footwear are recommended when working outdoors. wear protective hair covering to contain long hair. SAVE THIS MANUAL FOR FUTURE REFERENCE. RULES FOR SAFE OPERATION The purpose of safety rules is to attract your attention to possible dangers. The safety symbols and the explanations with them, require your careful attention and understanding. The instruction or warnings they give are not substitutes for proper accident prevention measures. DO NOT OPERATE THIS TOOL WHILE UNDER THE INFLUENCE OF DRUGS, ALCOHOL OR ANY MEDICATION. THE APPLIANCE IS NOT INTENDED FOR USE BY YOUNG OR INFIRM PERSONS WITHOUT SUPERVISION. YOUNG CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY DO NOT PLAY WITH THE APPLIANCE. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE Due to continued product refinement policy, product features and specifications can and will change w thout notice. Check current features and specifications with your retailer. FEATURES 1 4 R 2 5 6 7 3 8 1. Trigger Switch APPLICATIONS (use only for the purposes listed below). Drilling concrete MOUNTING OF BIT (Fig 1. ) When mounting the bit, first pulling open rear half of the chuck to release the lock, insert the bit into the chuck as far as it will go and hand tighten the chuck to secure the bit, then pushing rear half of the chuck to lock it. The bit can be removed by reversing above procedure. Fig 3. R L Forward Reverse Lever Fig 1. VARIABLE SPEED (Fig 4. ) Your drill has a variable speed control mechanism designed to allow the operator control and adjustment of speed and torque limits. The speed and torque of your drill can be increased by rotating the variable speed control button. Fig 4. SWITCHES (Fig 2. ) Your drill starts and stops by squeezing and releasing the trigger switch. For continuous operation, press the lock-on button while the trigger switch is fully depressed. To release the lock, squeeze the trigger switch again. Variable Speed Control HAMMER MECHANISM (Fig 5. ) Fig 2. When drilling materials that are liable to break, such as tiles, it is advisable to start the drill without impact. [. . . ] WARNING: The chuck and exposed metal surfaces of the tool may become "live" if the tool drills into wiring in a wall. The operator must always ensure that the area being drilled dose not conceal electrical wiring or plumbing. DRILLING IN WOOD (Fig 6. ) To prevent ugly splits around the drillhole on the reverse side of the workpiece, place a scrap piece of timber beneath the material to be drilled. Fig 6. Fig 8. AUXILIARY HANDLE AND DEPTH STOP Install the auxiliary handle on the head of the housing and insert the depth stop in the hole provided. [. . . ]