User manual RYOBI 720R1-SERIALS102055901-THRU-203096320

[. . . ] There is an increased risk of electric shock if your body is earthed or grounded. Never use the cord for carrying, pulling or unplugging the power tool. e) When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. [. . . ] f) If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of electric shock. Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications 3) Personal safety a) Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in a serious personal injury. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. Carrying power tools with your finger on the switch or energising power tools that have the switch on invites accidents. d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. Take care that your hand does not cover the vents and make sure oil or water does not come into contact with the motor. ¡ö ¡ö WARNING: This sander is designed for light consumer use. It is NOT designed for trade or industrial use and is not covered by the guarantee for use in these applications. SPECIFICATIONS Power input: No load speed: Sanding pad size: Net weight: 200 W 5, 000-10, 000 min 90 x 184 mm 1. 75 kg -1 OPERATION It is recommended that the tool always be supplied via a residual current device with a rated residual current of 30mA or less. FITTING THE SANDPAPER WARNING: Never cover the air vents. They must be open at all times for proper motor cooling. DUST COLLECTION BOX ¡ö SPECIFIC SAFETY WARNINGS ¡ö ¡ö ¡ö ¡ö ¡ö Use clamps or other practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body leaves it unstable and may lead to loss of control. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will also make exposed metal parts of the tool "live" and shock the operator. Learn its applications and limitations, as well as the specific potential hazards related to this power tool. Following this rule will reduce the risk of electric shock, fire or serious injury. Following this rule will reduce the risk of eye injury. ¡ö ¡ö ¡ö ¡ö WARNING: Always remove the electric cord from the power supply when changing sanding paper, polishing pad or when working on the tool. Ensure the sandpaper is taut on the base with the edges and dust collection holes evenly aligned (Fig. [. . . ] Following this rule will reduce the risk of eye injury. ¡ö ¡ö ¡ö ¡ö WARNING: Always remove the electric cord from the power supply when changing sanding paper, polishing pad or when working on the tool. Ensure the sandpaper is taut on the base with the edges and dust collection holes evenly aligned (Fig. Pull out both the front and rear clamping levers to the open position and insert the ends of the sandpaper under both clamps. (Fig. 4) ¡ö ¡ö ¡ö ¡ö ¡ö ¡ö Your sander is equipped with a dust collection box. [. . . ]