User manual RYOBI 710R-SERIALS-301112306-AND-GREATER

[. . . ] Any power tool that can not be controlled with the switch is dangerous and must be repaired. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. [. . . ] Never use the cord for carrying, pulling or unplugging the power tool. When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock. If operating power tools in a damp location is unavoidable, use a residual current device (RCD) protected supply. Use of an RCD reduces the risk of electric shock. English dangerous in the hands of untrained users. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. Use the power tool, accessories and tool bits etc. , in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from intended could result in a hazardous situation. Have your power tool serviced by a qualified repair person using only identical replacement parts. Recommended for the use of a residual current device with a rated residual current of 30 mA or less. SAFETY PRECAUTIONS IMPORTANT To protect yourself from the risk of electric shock, injury and fire when using an electric tool, it is imperative to take the following basic safety precautions. Push and rotate the dust-free tool into the bit holder as far as it will go. REMOVING THE BIT FROM THE SDS-PLUS SYSTEM Pull back the locking collar and remove the bit. CHUCK ADAPTOR (IF INCLUDED) For drilling work in metal, wood and plastic with drill bits that have non SDS plus shaft, the drill adaptor is available. SWITCHING ON/OFF Speed control The speed of the drill may be varied by increasing the pressure exerted on the trigger. To limit the maximum speed of the drill, rotate the dial on the front of the trigger until the desired setting is achieved. Lock-on button If you want to keep your hammer drill operating at a constant speed, press the lock-on button while pressing the variable switch. To unlock this function, briefly press the variable switch then release it. For reasons of safety, only use the hammer drill when it is fitted with the auxiliary handle. To loosen the auxiliary handle, rotate the handle anticlockwise until the handle is free to move. Position the handle as required then lock securely by rotating the handle clockwise until it is tight. The depth of the hole drilled will be equal to the distance between the end of the drill bit and the front end of the depth stop. SPECIFICATIONS Voltage Power consumption No-load speed (Drill mode) Hammer speed (Blows per minute) Impact energy Tool attachment Weight Maximum drilling capacity steel concrete/stone 13 mm 24 mm 240 V 710 W 0-1100 min-1 0-4000 min-1 2. 0 J SDS-plus 3. 0 kg 50 Hz OPERATION BEFORE STARTING TO USE YOUR HAMMER DRILL Examine the place where the tool is to be used for hidden electrical cables, gas, and water pipes using a pipe finding device. [. . . ] NOTE: Anti-clockwise rotation during impact drilling damages the drill bit. ROTATION STOP The mode selector on the ERH710RG features a third position, Rotation Stop Mode , which stops the rotation of the tool whilst maintaining the hammer action. This feature enables the tool to be used for chiselling, when fitted with the appropriate bit. REVERSING THE DIRECTION OF ROTATION The direction of rotation of the drill may be changed by the use of the reverse lever on the switch, situated above the trigger. [. . . ]