User manual RYOBI 705R-SERIALS-611000001-AND-UP

[. . . ] Read the whole manual and follow all the instructions to keep your new outdoor power tool in top operating condition. The other manual that came with your power tool, the parts manual, contains all the information that you need to order parts. 12 PRODUCT REFERENCES, ILLUSTRATIONS AND SPECIFICATIONS All information, illustrations and specifications in this manual are based on the latest product information available at the time of printing. Click-Link® and SpeedSpool® are registered trademarks of Ryobi Outdoor Products. [. . . ] To change from one add-on to another NOTE: To make installing or removing the add-on easier, place the unit on the ground or on a work bench. Click-Link® Release Button 90° Edging Hole Knob Washer 180° Edging Hole Fig. While firmly holding the add-on, push straight into the Click-Link® shaft (Fig. NOTE: Aligning the release button with the guide recess will help installation (Fig. CAUTION: Lock the release button in the primary hole and securely tighten the knob before operating this unit. While firmly holding the upper shaft housing, pull the add-on straight out of the Click-Link® (Fig. 13). Basic Trimming or Using Other RYOBI Add-Ons: Lock the release button in the Primary Hole in the Click-Link® (Fig. 13). Edging with the Cutting Attachment Lock the release button in the 90° Edging Hole or the 180° Edging Hole in the Click-Link® (Fig. 14). 13 OPERATING INSTRUCTIONS HOLDING THE TRIMMER WARNING: Always wear eye, hearing, foot and body protection to reduce the risk of injury when operating this unit. Check for the following: · The operator is wearing eye protection and proper clothing. · The right arm is slightly bent, and the hand is holding the shaft grip. Before installing new trimming line in the existing inner reel, pull old line out of the line loading and line locking holes (Figs. WARNING: Always use the correct line length when installing trimming line on the unit. Line up the arrow on the inner reel with the arrow on the outer spool (Fig. Top View Of The SpeedSpool® Outer Spool Arrows Line Locking Hole Fig. Pull the line from the outer spool until the line is tight against the inner reel (Fig. Wind the inner reel counterclockwise until approximately four (4) inches (102 mm. ) of line remain (Fig. NOTE: Do not wind the inner reel before installing the second piece of line. Fig. Insert a piece of trimming line into one of the two eyelets in the outer spool. Do not bend the line when inserting it into the eyelet. 16 MAINTENANCE AND REPAIR INSTRUCTIONS Fig. If winding the line becomes difficult or the line jams, pull the ends of the line from the spool. Hold the inner reel in place and install the bump knob, spring and foam seal by pressing down and turning the bump knob clockwise. [. . . ] The manufacturer is not liable to cover failures or warranted parts caused by the use of add-on or modified parts. In order to file a claim, go to your nearest Authorized Ryobi Service Center. Warranty services or repairs will be provided at all Authorized Ryobi Service Centers. Any manufacturer approved replacement part may be used in the performance of any warranty maintenance or repair of emission related parts and will be provided without charge to the owner. [. . . ]