User manual RYOBI 700W JIGSAW EJS700RG

[. . . ] EJS700RG JIGSAW OWNER'S OPERATING MANUAL DESCRIPTION Switch Lock-on button Safety guard Base Degree marks Saw blade Dust port (connect to dust extraction system, not included) 8. LED worklight 14 2 16 1 13 15 7 3 19 5 11 4 17 9 8 25 18 Fig. 12 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications. English GENERAL POWER TOOL SAFETY WARNINGS 3. [. . . ] Children should be supervised to ensure that they do not play with the appliance. This appliance is not intended for use by young children or infirm persons. Adequate supervision by a 2 English SPECIFICATIONS Voltage Input power Stroke per minute Stroke length Max cutting capacity Wood Steel 85 mm 8 mm TRANSPARENT GUARD See Figure 3. For your protection, a transparent guard has been included with the saw. The transparent guard is attached by placing it in front of the blade area of the base and snapping it into the tabs on the sides of the saw base. 240 V 680 W 800 - 3000 min-1 21 mm 50 Hz disengage the lock-on feature immediately. WARNING Before connecting your saw to power supply source, always check to be sure it is not in lock-on position (depress and release trigger switch). Failure to do so could result in accidental starting of your saw resulting in possible serious injury. Also, do not lock the trigger on jobs where your saw may need to be stopped suddenly. FEATURES KNOW YOUR SAW Before attempting to use your saw, familiarize yourself with all operating features and safety requirements. It should be connected only to a power supply of the type specified by its rating plate. A substantial voltage drop will cause a loss of power and overheating. If your tool does not operate when plugged into an outlet, double-check the power supply. WARNING Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. WARNING Failure to unplug your saw could result in accidental starting causing possible serious injury. Rotate the quick release lever counter-clockwise and hold in position. Insert the saw blade into the groove in the roller guide, making sure the back of the saw blade is properly positioned in the groove. Your saw is equipped with a lock-on feature, which is convenient when continuous cutting for extended periods of time is required. To lock-on, depress the trigger switch, push in and hold the lock-on button located on the side of the handle, then release trigger switch. If you have the lock-on feature engaged during use and your saw becomes disconnected from power supply, 3 English WARNING To avoid possible serious injury, always wear safety goggles or safety glasses with side shields. Keep hands and fingers away, from the motor housing and blade clamp and do not reach underneath work while blade is cutting. To close: Push the door up with your thumb or finger. WARNING Do not insert saw blade into air vents. They could come in contact with electrically live internal parts and cause electric shock, resulting in serious injury. WARNING To avoid serious personal injury, do not use saw without safety guard properly in place. WARNING Your saw should never be connected to power supply when you are assembling parts, making adjustments, installing or removing blades or when not in use. [. . . ] Tilt your saw forward so that it rests on the front edge of the base and blade will not come in contact with the workpiece when the saw is turned on. This allows the air to flow out around the blade blowing sawdust and chips away from the operators view of the line of cut. TO INSTALL: Unplug your saw. English WARNING Failure to unplug your saw could result in accidental starting causing possible serious injury. Depress the trigger switch to generate a red laser beam on the work surface in front of the saw. [. . . ]