User manual RYOBI 600W JIGSAW EJS600RG

[. . . ] A wrench or a key left attached to a rotating part of the power tool may result in personal injury. This enables better control of the power tool in unexpected situations. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. The correct power tool will do the job better and safer at the rate for which it was designed. [. . . ] Do not let visitors contact tool or extension 2 WARNING Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury. OPERATION SWITCH See Figure 1. Your saw is equipped with a lock-on feature, which is convenient when continuous cutting for extended periods of time is required. To lock-on, depress the trigger switch, push in and hold the lock-on button located on the side of English the handle, then release trigger switch. If you have the lock-on feature engaged during use and your saw becomes disconnected from power supply, disengage the lock-on feature immediately. Your saw has a variable speed control selector designed to allow operator control and adjustment of speed and power limits. The speed and power of your saw can be increased or decreased by rotating the variable speed control selector in the direction of the arrows. NOTE: Hold your saw in normal operating position and turn the variable speed control selector counterclockwise to increase speed and power. If you wish to lock the switch on at a given speed, depress the trigger switch, push in and hold the lock-on button, and release the trigger switch. Next, adjust the variable speed control selector until the desired speed is reached. Running at low speeds under constant usage may cause your saw to become overheated. If this occurs, cool your saw by running it without a load and at full speed. The following guidelines may be used in determining correct speed for various applications. LOW speed is ideal when minimum speed and power is required, for example starting cuts. MEDIUM speed is suitable for cutting hard metals, plastics and laminates. HIGH speed produces best results when maximum power is required, for example cutting wood. Soft metals such as aluminum, brass and copper also require high speeds. To close: Push the door up with your thumb or finger. WARNING Before connecting your saw to power supply source, always check to be sure it is not in lock-on position (depress and release trigger switch). Failure to do so could result in accidental starting of your saw resulting in possible serious injury. Also, do not lock the trigger on jobs where your saw may need to be stopped suddenly. TO INSTALL BLADES See Figure 3. Unplug the tool. WARNING Failure to unplug your saw could result in accidental starting causing possible serious injury. Rotate the quick release lever counter-clockwise and hold in position. [. . . ] Therefore, no 5 WARNING Failure to unplug your saw could result in accidental starting causing possible serious injury. Insert arm of the edge guide through the two slots in the base of your saw. Adjust edge guide to the desired width and lock in place with the edge guide screw. WARNING When servicing, use only identical replacement parts. Use of any other part may create a hazard or cause product damage. English further lubrication is required. [. . . ]