User manual RYOBI 216.51716

[. . . ] Subject to technical modifications. English GENERAL POWER TOOL SAfETy WARNINGS WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. The term "power tool'' in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. NOTE: The term ''residual current device (RCD)'' may be replaced by the term ''ground fault circuit interrupter (GFCI)'' or ''earth leakage circuit breaker (ELCB)''. PERSONAL SAfETy WORK AREA SAfETy Keep work area clean and well lit. [. . . ] The handle can be mounted on the opposite side for left or right hand use. Insert handle screw into hole located above trigger switch and seat hex head into hole. Slide handle collar onto screw, seat hex end of collar into hex hole. Slide depth stop rod into hex shaped hole on top of collar. English ASSEMBLy Slide depth guide clamp into notch in collar. NOTE: When properly installed, the teeth on the depth stop rod should be aligned with the teeth indicator on the depth stop rod clamp. NOTE: Be sure the auxiliary handle is securely tightened against the depth stop rod clamp. WARNING Always wear safety goggles or safety glasses with side shields when operating products. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. WARNING Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this product for the purposes listed below: Drilling in all types of wood products (lumber, plywood, panelling, composition board, and hard board) Drilling in ceramics, plastics, fiberglass, and laminates Drilling in metals Driving screws Hammer drilling in brick, or other masonry This product will accept RYOBI One+ 18 V lithium-ion battery packs and RYOBI One+ 18 V nickel-cadmium battery packs. To stop the drill, release the trigger switch and allow the chuck to come to a complete stop. NOTE: The drill will not run unless the rotation selector is pushed fully to the left or right. Running at low speeds under constant usage may cause the drill to become overheated. If this occurs, cool the drill by running it without a load and at full speed. INTERNAL SPINDLE LOCK The internal spindle lock allows the user single-handed control of chuck adjustments and bit changes. For bit changes and chuck adjustments, squeeze the chuck body and turn. The drill has a keyless chuck to tighten or release drill bits in the chuck jaws. The arrows on the chuck indicate which direction to rotate the chuck body in order to LOCK (tighten) or UNLOCK (release) the drill bit. WARNING Do not hold the chuck with one hand and use the power of the drill to tighten the chuck jaws on the drill bit. The chuck body could slip in your hand, or your hand could slip and come in contact with the rotating drill bit. MODE DRILL MODE (TORQUE ADJUSMENT NOT ACTIVE) 1/LOW DRIVE MODE 2/HIGH 1/LOW 2/HIGH may be damaged or broken. [. . . ] Lock the trigger switch by placing the rotation selector in the center position. Open or close the chuck jaws to a point where the opening is slightly larger than the bit size you intend to use. Also, raise the front of the drill slightly to keep the bit from falling out of the chuck jaws. WARNING: Make sure to insert the drill bit straight into the chuck jaws. [. . . ]