User manual RYOBI 2000W SLIDE COMPOUND MITRE SAW 254MM EMS2026SCL

[. . . ] Slide the other leg of the square against the flat part of saw blade(b). (Fig. 14a) Note: Make sure that the square contacts the flat part of the saw blade, not the blade teeth. The edge of the square and the saw blade should be parallel as shown in Fig. [. . . ] Connect the link to the lower blade guard. Page 13 ADJUSTMENT Unlock the bevel lock lever(16) and move the saw arm to the 0o position and lock the bevel lock lever. (Fig. 16) Lay the combination square(b) on the mitre table(11) and against the blade(a). 17) Unscrew the 0o bevel positioning bolt on the right hand side by using a hex key(a). (Fig. 18) Correctly align the blade(a) and mitre table (11) using the combination square and lock the bevel lock lever. If the table and the blade do not align, readjust the 0o bevel positioning bolt until aligned(Fig. 20), then adjust the pointer(b) to 0o mark and secure by tightening the pointer screw(c) (Fig. 22) When the saw arm is rotated at the 45o bevel position, check 45o angle by using at 45o set square from the table to the blade. If the table and blade do not align, readjust the 45o positioning bolt(a) on the left until aligned. The saw blade can cut deeper by turning the depth cut adjustment screw(26) counterclockwise and cut lesser by turning this screw(26) clockwise. Lower the blade into the throat plate of mitre table, then check the maximum cutting depth. To prevent the depth of cut adjustment screw (26) from turning, tighten the hex nut(a) carefully against the fence(13). WARNING: To avoid the risk of personal injury or damage to the unit, check that the blade is not in contact with an element of the table. ADJUSTING THE MITRE LOCK (Fig. 26) After a period of time, you may need to readjust the locking mechanism. To readjust: Loosen the set screw under the mitre lock knob(9) by a hex key. 26a) Turn the mitre lock knob(9) clockwise until the turntable is firmly locked. 26b) Fasten the set screw so that the new turning angle of the handle to lock the table is redefined. 26c) OPERATION APPLICATIONS (Use only for the purposes listed below) Cross Cutting wood. [. . . ] The Company accepts no additional liability pursuant to this guarantee for the costs of travelling or transportation of the Product or parts to and from the service dealer or agent - such costs are not included in this guarantee. Certain legislation, including the Trade Practices Act, 1974 (as amended) and other state and territorial laws give rights to the buyer and impose liability on the seller in certain circumstances. Nothing herein shall have the effect of excluding, restricting or modifying any condition, guarantee, right or liability imposed, to the extent only that such exclusion, restriction or modification would render any term herein void. A. B. N. [. . . ]