User manual RYOBI 2000W HEAT GUN DUAL TEMP / VARIABLE HEAT EHG2002LED

[. . . ] Inspect the heat gun cable regularly and if damaged, have it repaired by authorized service centre. When the heat gun is used outdoors, use only extension cables that are suitable or exterior use. When working on small or irregular shaped objects, clamp the object in a vice or clip. [. . . ] Flakes and residues of lead-based paints are highly toxic. POWER SUPPLY Ensure that the power supply corresponds to the rating plate on the heat gun. The power supply should be 240V 50HzAC (normalmains). Voltage deviation greater than 10% may cause loss of power and possible overheat. This means that there are two separate insulation systems between the user and the live elements of the heat gun. Warning: Although the heat gun is double insulated, normal safety precautions should be taken when using the heat gun to avoid injury that may be caused by a failure of the electrial installation inside the equipment. This tool is not designed to be earthed. The heat gun power cable is, therefore fitted with a two pin plug for use in normal 240V power sockets. SPECIFICATION Model No. : Rating: Voltage: Frequency: Temperature: Air flow: EHG2002LED 2000W 240V 50Hz o 50 C-650oC 250 to 500 l/min EHG2002 2000W 240V 50Hz o 60 C and 600oC 250 and 500 l/min Variable temperature adjust: LED temperature indicator: Yes Yes 2 Temperature No DESCRIPTION 1. LED temperature indicator (For EHG2002LED only) USING THE HEAT GUN The heat gun is very easy to use. Before plugging the heat gun in, always ensure that the switch is set to 0. Always allow the heat gun to warm up for at least 1minute to reach the operating temperature. The heat gun has a built-in stand to keep it upright on a flat horizontal surface. This leaves both hands free for softening PVC pipes or other material. If your heat gun model has a variable temperature control (3) you can rotate this to adjust to different temperatures. If your heat gun model has LED temperature indicator (6) (Fig. 4) then you can take a reference on the LED indicator to know what is the approximate working temperature. Pape 3 STRIPPING PAINT AND VARNISH The following procedure and techniques make it easier to strip paint and varnish. Always test a small area of paint before attempting to strip large areas. Turn the heat gun on and allow it to warm up to operating temperature. Do not overheat the paint as this may burn it and make it more difficult to remove. Start by warming the surface just in front of the scraper uniformly by moving the heat gun slightly from side to side. [. . . ] Under the terms of this guarantee, the repair or replacement of any part shall be the opinion of the Company or its authorised agent. Should service become necessary during the warranty period, the owner should contact the RYOBI HELPLINE 1300 361 505 or contact the retailer from whom the product was purchased. In order to obtain guarantee service, the owner must present the sales docket and Guarantee Certificate to confirm date of purchase. [. . . ]