User manual RYOBI 2000W ANGLE GRINDER KIT 230MM EAG2023RG

[. . . ] A wrench or a key left attached to a rotating part of the power tool may result in personal injury. This enables better control of the power tool in unexpected situations. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. The correct power tool will do the job better and safer at the rate for which it was designed. [. . . ] Before each use inspect the accessory such as abrasive wheels for chips and cracks, backing pad for cracks, tear or excess wear, wire brush for loose or cracked wires. If power tool or accessory is dropped, inspect for damage or install an undamaged accessory. After inspecting and installing an accessory, position yourself and bystanders away from the plane of the rotating accessory and run the power tool at maximum no-load speed for one minute. Depending on application, use face shield, safety goggles or safety glasses. As appropriate, wear dust mask, hearing protectors, gloves and workshop apron capable of stopping small abrasive or workpiece fragments. The eye protection must be capable of stopping flying debris generated by various operations. The dust mask or respirator must be capable of filtrating particles generated by your operation. Anyone entering the work area must wear personal protective equipment. Fragments of workpiece or of a broken accessory may fly away and cause injury beyond immediate area of operation. Hold power tool by insulated gripping surfaces 2 SPECIAL SAFETY RULES This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. This appliance is not intended for use by young children or infirm persons. Adequate supervision by a responsible person must be provided to ensure that they do not play with the appliance. Visitors should wear safety glasses and be kept a safe distance from work area. Recommended for the use of a residual current device with a rated residual current of 30 mA or less. SAFETY INSTRUCTIONS FOR ALL OPERATIONS SAFETY WARNINGS COMMON FOR GRINDING AND ABRASIVE CUTTING: This power tool is intended to function as a grinder or abrasive cutter tool. Read all safety warnings, instructions, illustrations and specifications provided with this power tool. Failure to follow all English only, when performing an operation where the cutting accessory may contact hidden wiring or its own cord. Cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and shock the operator. If you lose control, the cord may be cut or snagged and your hand or arm may be pulled into the spinning accessory. Never lay the power tool down until the accessory has come to a complete stop. The spinning accessory may grab the surface and pull the power tool out of your control. Accidental contact with the spinning accessory could snag your clothing, pulling the accessory into your body. [. . . ] Always disconnect the power cord from the socket before changing removable or expendable parts (grinding disc, cutting disc etc), before lubricating or working on the unit. WARNING Do not adjust the overmold handle while the tool is in operation. Attach the disc flange and the wheel on the spindle before fitting the clamp nut. Ensure that the wheel is correctly seated over the boss on the disc flange and clamp nut with the flat side facing up. Using the wrench provided, tighten the clamp nut in a clockwise direction. WARNING To ensure safety and reliability, all repairs should be performed by an authorised service center or other qualified service organization. [. . . ]