User manual RYOBI 18V ONE PLANER CPL1800G

[. . . ] OPERATOR'S MANUAL 18 VOLT HAND PLANER CPL1800 BATTERIES AND CHARGERS SOLD SEPARATELY Your planer has been engineered and manufactured to our high standard for dependability, ease of operation and operator safety. When properly cared for, it will give you years of rugged, trouble-free performance. this product. WARNING: To reduce the risk of injury, the user must read and understand the operator's manual before using Thank you for buying a Ryobi product. SAVE THIS MANUAL FOR FUTURE REFERENCE TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 General Safety Rules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To remove the dust bag, grasp the adaptor and pull the dust bag away from the planer. 3 OPERATION WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. NOTE: Batteries will not reach full charge the first time they are charged. Allow several cycles (operation followed by recharging) for them to become fully charged. CHARGING A COOL BATTERY PACK If battery pack is within normal temperature range, the red LED on charger will come on. NOTE: If the charger does not charge the battery pack under normal circumstances, return both the battery pack and charger to your nearest Authorised Service Centre for electrical check. Make sure the power supply is normal household voltage, 240 volts, 50 Hz, AC only. Place the battery pack in the charger aligning raised rib on the battery pack with the groove in the charger. Press down on the battery pack to be sure contacts on the battery pack engage properly with contacts in the charger. Red LED should remain on for approximately 1 hour then the green LED will come on. Green LED on indicates battery pack is fully charged and charger is in maintenance charge mode. NOTE: The green LED will remain on until the battery pack is removed from the charger or charger is disconnected from the power supply. If both yellow and green LEDs come on, this indicates a deeply discharged or defective battery pack. When the battery pack reaches normal voltage range, the red LED should come on. If the red LED does not come on after 30 minutes, this may indicate a defective battery pack that should be replaced. After normal usage, a minimum of 1 hour of charging time is required to fully recharge battery pack. The battery pack will become slightly warm to the touch while charging. Do not place the charger and battery pack in an area of extreme heat or cold. NOTE: The charger and battery pack should be placed in a location where the temperature is more than 0°C but less than 37°C . When batteries become fully charged, unplug the charger from power supply and remove the battery pack. WARNING: Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this tool for the purposes listed below: Planing the edge of a wooden door or shelf Planing the edge of a piece of timber Making rebate cuts in timber CAUTION: If at any point during the charging process none of the LEDs are lit, remove the battery pack from the charger to avoid damaging the product. [. . . ] If necessary, tap the block of wood sharply with a small hammer to break the blades loose. INSERTING THE NEW BLADE Clean any sawdust or wood chips from around the blade area. Use a screwdriver to push the blade into the blade holder until it is centered into position. 16 17 MAINTENANCE REPLACING THE BELT See Figures 17 - 18. When replacing the belt, use recommended replacement belt only (Part No. [. . . ]