User manual RYOBI 14.4V IMPACT DRILL DRIVER KIT WITH AUX HANDLE CBI1442D

[. . . ] This enable better control of the power tool in unexpected situations. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly use. The correct power tool will do the job better and safer at the rate for which it was designed. Any power tool that can not be controlled with the switch is dangerous and must be repaired. [. . . ] 1) The battery packs for this tool have been shipped in a low charge condition to prevent possible problems. Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (drilling followed by recharging) for the item to fully charge. Make sure power supply is normal house voltage, 240VoHs, 50Hg, AC only. Press down on battery pack to make sure contacts on battery pack engage properly with contacts in charger. After normal usage, 1 hour of charging time is required for the battery to be fully charged. Note: Normally the red light on the charger will come on, this indicates charge mode. If the green and yellow lights come on, remove the battery pack, wait 1 minute and reinsert battery pack in charger. If the green and yellow lights continue to remain on an additional 15 minutes, the battery pack is damaged and will not accept charge. A maximum charge time of 1-1 1/2 hours is required to recharge a completely discharged battery. The battery pack will become slightly warm to the touch while charging. When the batteries become fully charged, the green light on charger will turn on. LED FUNCTION OF CHARGER Red Green and yellow Green Fast charging mode Control charge or defective Fully charged TO INSTALL BATTERY PACK (fig. 2) Lock the switch trigger by placing the direction of rotation selector in the central position. To install, insert battery pack neck into drill's battery port, making sure the latches on each side snap into place and battery pack is secure before beginning operation. To remove, locate latches on side of battery pack and depress both sides to release battery pack from drill. It will be turned on when the button is pressed, and will be turned off when the button is released. Note: Indicator is for reference only and can vary according to ambience and application. For the LCD display, it so be read when you push the LCD button and the drill is on; if the drill is off, the display does not reflect actual battery capacity when you push the LCD button. 3) The drill is started and stopped by depressing and releasing the switch trigger. This helps to reduce the possibility of accidental starting when not in use. To lock the switch trigger, place the direction of rotation selector in the centre position. Page 3 OPERATION DIRECTION OF ROTATION The direction of rotation is controlled by the direction of rotation selector located above the switch trigger. [. . . ] guarantee service, the owner must docket and Guarantee Certificate purchase. This product is sold by the principal and the dealer has no e Company to give any additional Company's behalf except as herein n referred to. itions ly applies provided that the Product accordance with the manufacturer's s under normal use and reasonable nion of the Company) and such wear and tear. The Company accepts no additional this guarantee for the costs o transportation of the Product or par service dealer or agent - such costs a this guarantee. [. . . ]