User manual RYOBI 14.4V IMPACT DRILL DRIVER KIT CID1442P

[. . . ] CID1442P/CID1802P THANK YOU FOR BUYING A RYOBI CORDLESS IMPACT DRILL-DRIVER. Your new cordless impact drill-driver has been engineered and manufactured to Ryobi's high standard for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. CAUTION: Carefully read through this entire operator's manual before using your new cordless impact drill-driver . [. . . ] A minimum charge time of 6 hours is required to recharge a completely discharged battery. The battery pack will become slightly warm to the touch while charging. When battery pack has been charged, disconnect charging assembly from power supply and remove the battery pack. This practice will increase battery life. I I I I I TWO SPEED GEAR TRAIN See Figure 1B. Your drill has a two-speed gear train designed for drilling or driving at LO (1) or HI (2) speeds. A slide switch is located on top of your drill to select either LO (1) or HI (2) speed. When using drill in the LO (1) speed range, speed will decrease and unit will have more power and torque. When using drill in the HI (2) speed range, speed will increase and unit will have less power and torque. Use LO (1) speed for high power and torque applications and HI (2) speed for fast drilling or driving applications. Page 7 OPERATION MODEL CID1802P LED FUNCTION OF CHARGER 2601038 See Figure 2. . LED WILL BE LIGHTED TO INDICATE STATUS OF CHARGER AND BATTERY PACK: Red LED lighted = Fast Charging Mode Green LED lighted = Fully Charged Battery Pack Yellow and Green LED Lighted = Control Charge or Defective Battery Pack. CHARGING BATTERY PACK The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. NOTE: Batteries will not reach full charge the first time they are charged. Allow several cycles (cutting followed by recharging) for them to fully charge. Make sure power supply is normal house voltage, 240 Volts, 50 Hz, AC only. Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charger. This indicates charger is in control charge mode and should switch to fast charge mode within 5 minutes. If after a period of 15 minutes the yellow and green lights remain on, remove the battery pack, wait 1 minute and reinsert battery pack in charger. If the yellow and green lights continue to remain on an additional 15 minutes, the battery pack is damaged and will not accept charge. When your battery pack becomes fully charged, the red light will turn off and the green light will turn on. After normal usage, 1 hour of charge time is required to be fully charged. A minimum charge time of 1 to 1-1/2 hours is required to recharge a completely discharged tool. The battery pack will become slightly warm to the touch while charging. When the batteries become fully charged, unplug your charger from power supply and remove the battery pack. Fig. 2 IMPORTANT SAFETY WARNING!! CORDLESS CUTTING TOOLS CAN BE EXTREMELY DANGEROUS IF NOT HANDLED CORRECTLY AND WITH PROPER CAUTION. [. . . ] To tighten, follow these steps: I I I Lock the switch trigger by placing the direction of rotation selector in center position. 13 Page 13 MAINTENANCE WARNING: When servicing use only identical Ryobi replacement parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Abusive practices can damage the tool, as well as the work piece. WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. [. . . ]