User manual RYOBI 1050W IMPACT DRILL EID1050RB

[. . . ] Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. Never use the cord for carrying, pulling or unplugging the power tool. [. . . ] Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. Use the power tool, accessories and tool bits etc. , in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from intended could result in a hazardous situation. Recommended for the use of a residual current device with a rated residual current of 30 mA or less. safety glasses and be kept a safe distance from work area. Complies with AS/NZS 60745. 2. 1 and 60745. 1. SPECIFICATIONS Voltage Chuck capacity Drilling capacity in wood in steel in masonry Input No load speed Blows per minute Weight EID1050RB 240 V 50 Hz 13 mm (1/2") 32 mm 13 mm 20 mm 1050 W 0 - 3, 200 min-1 0 - 51, 000 min-1 2. 86 kg STANDARD ACCESSORIES Auxiliary handle and Depth Gauge. SERVICE Have your power tool serviced by a qualified repair person using only identical replacement parts. Hold the power tool by the insulated grips when performing an operation where the cutting accessory may contact hidden wiring or its own cord. A cutting accessory contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. This appliance is not intended for use by young children or infirm persons. Adequate supervision by a responsible person must be provided to ensure that they do not play with the appliance. Visitors should wear 2 OPERATION APPLICATIONS (Use only for the purposes listed below. ) Drilling wood, materials and resin boards. Drilling metal: steel, brass, aluminum sheets, stainless steel & pipe. SWITCH See Figure 1 & 3. This tool can be started and stopped by squeezing and releasing the trigger switch (1). The speed can be adjusted by controlling the force applied to the trigger. The maximum speed of the drill may be set at different speeds by adjusting the variable speed selector (4). For continuous operation, press the lock-on button (5) while squeezing the trigger. [. . . ] When drilling in delicate materials such as wall tiles, it is essential to start with ordinary drilling and, once the tile is pierced, to continue with impact drilling. In deep bore holes the drill bit should be pulled out occasionally in order to remove the debris from the 3 LIVETOOL INDICATORTM This tool features a Livetool IndicatorTM (11) which illuminates as soon as the tool is connected to the power supply. This warns the user that the tool is connected and will operate when the switch is pressed. English MAINTENANCE After use, check the tool to make sure that it is in good condition. [. . . ]