User manual ROYAL RC-BCPM01

[. . . ] There is an increased risk of electric shock if the earthed device is exposed to rain, comes into direct contact with a wet surface or is operating in a damp environment. Water getting into the device increases the risk of damage to the device and of electric shock. Keep the cable away from heat sources, oil, sharp edges or moving parts. E) If using the device in a damp environment cannot be avoided, a residual current device (RCD) should be applied. [. . . ] F) Device repair or maintenance should be carried out by qualified persons, only using original spare parts. G) To ensure the operational integrity of the device, do not remove factory-fitted guards and do not loosen any screws. J) Clean the device regularly to prevent stubborn grime from accumulating. Cleaning and maintenance may not be carried out by children without supervision by an adult person. M) It is forbidden to interfere with the structure of the device in order to change its parameters or construction. Despite the safe design of the device and its protective features, and despite the use of additional elements protecting the operator, there is still a slight risk of accident or injury when using the device. USE GUIDELINES The device is designed for rolling egg-and-flour cakes and cutting them to various thicknesses for consumption. The user is liable for any damage resulting from unintended use of the device. APPLIANCE LOCATION The temperature of environment must not be higher than 40°C and the relative humidity should be less than 85%. Ensure good ventilation in the room in which the device is being used. There should be at least 10 cm distance between each side of the device and the wall or other objects. The device should always be used when positioned on an even, stable, clean, Fireproof and dry surface, and be out of the reach of children and persons with limited mental and sensory functions. Position the device such that you always have access to the power plug. The power cord connected to the appliance must be properly grounded and correspond to the technical details on the product label. Portafilter in the brew head aligning the handle with the Then turn it until you feel resistance and The handle is aligned with the LOCK caption. Connect the device to the power Supply (the steam knob should be in the OFF position). After it is finished, the device will go into After a small Amount of water flows out, press the button again to stop. Repeat for the SINGLE and DOUBLE Fill the tank with cold water not exceeding the Check that the steam knob is in the OFF position. the Device will go into preheating mode, the button backlight will start to flash. After preheating, the device goes into standby mode, all buttons on the control panel light up. ADJUSTING THE GRINDING DEGREE In order to grind coffee beans, set the appropriate value on the grinder knob (the smaller the value, the finer the ground beans are). GRINDING COFFEE Insert the portafilter with the strainer (for 1 or 2 coffees) into the grinder mount and lightly press it to the front until the required amount of ground coffee is obtained. [. . . ] If the pressure gauge shows a pressure between 12-20 bar, the pressure is too high. Reduce the tamping force of the ground coffee with The pad, then try again. CLEANING AND MAINTENANCE a) Unplug the mains plug and allow the device to cool Completely before each cleaning, adjustment or replacement of accessories, or if the device is not being used. D) After cleaning the device, all parts should be dried completely before using it again. [. . . ]