User manual ROYAL SOVEREIGN NPH-900N

[. . . ] b) Automatic overheating protection--If a temperature sensor should fail, the heating elements will not heat up. Temperature and speed can be adjusted, to properly laminate various film thickness. Thermostats are used to economically maintain consistent temperature. EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 4 SPECIFICATIONS Description Dimensions(w x d x h) Max. Laminating Width Max. Lam. Thickness Film Thickness Transport Type Heat Source Pre-Heating Time Temp. [. . . ] Use up and down arrows to set (Speed & Temperature), light blinks. To enter other settings into memory, repeat steps 2 and 3. MEMORY or button. 3. When you complete the optimum laminating conditions This setting is memorized and confirmed when the MEMORY 2) Using the memorized settings 1. The speed will always be shown "2" and there is no memory setting this function. Speed can be varied 0 to 7 by selecting HOT/COLD or button 4. You can release the machine from cold mode by pressing HOT/COLD EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 11 LAMINATING STEPS 1. It is ready when the LCD window shows and button. and the buzzer rings three times. 5. After Insert document or photograph to be laminated into a laminating pouch, insert pouch squarely into opening slot. When the machine is on for an extended period of time, use a slightly lower temperature setting as the internal temperature of the machine may actually be higher than the preset temperature, which may cause the document may ripple or bend. When you are finished laminating, press the power button to turn off. ***USEFUL INFORMATION*** * When continuously laminating, the ready signal ( waiting signal may be displayed on LCD window. At this time, if pouch is being laminated, finish laminating and then laminate new one after is showed. ) may disappear and the * Do not laminate empty or thin pouch on a thick film setting. This could be fatal for the rollers due to the high internal temperature. EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 12 2. It is ready when LCD window shows and the buzzor rings three times. 4. Insert document into a Royal Sovereign cold laminating pouch as follows. **HOW TO ATTACH DOCUMENT ON COLD POUCH FILM** 1) Prepare cold pouch film. 2) Remove protective paper inside cold pouch. Back (Be careful not to allow the pouch to close and seal itself closed. If the pouch closes on itself and seals, you will not be able to the document to be laminated inside. ) Front 3) Place document squarely into the pouch, where the protecting paper was. Cold film's minimum border of about 3mm(1/8") is necessary to provide a proper edge seal. 4) Beware of dust while inserting document. Back 5) Feed pouch squarely into opening slot. When you are finished laminating, press the power button to turn off. ***USEFUL INFORMATION*** If it has recently been used for hot lamination, allow the rollers to be cooled down about 20~30 minutes. EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 13 3. COLOR FOIL LAMINATING **Your laminator has ability to add color by applying color foil to documents copied or printed by lasor printer or toner copier. ** **PAPER CARRIER is required** 1. [. . . ] This warranty does not cover incidental or consequential damages resulting from its use. This warranty is not to be considered a service contract, and does not cover routine adjustment, cleaning, jams or removal of materials that have become stuck inside machine. This warranty does not cover damage or injury resulting from improper use or failure to follow the instruction manual provided. In no event will manufacturer, importer, warranty service center, its agents or assigns, be liable for losses, either direct or indirect, including but not limited to special, incidental, consequential, or punitive damages whatsoever incurred arising out of any breach of warranty by manufacturer, importer, warranty service center, their heirs or assigns or successors in interest. [. . . ]