User manual ROYAL SOVEREIGN NB-1900N

[. . . ] The electrical outlet should be installed near the equipment and should be easily accessible. EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 3 CHARACTERISTICS OF LAMINATOR NB-1900N LAMINATOR NB-1900N is an advanced laminator of contemporary design, utilizing the lastest in laminating technology. 1) The microprocessor protects the rollers Even when power is off, rollers continue to turn until properly cooled down. In the event of a power failure, rollers continue turning until properly cooled down. 2) The microprocessor prevents overheating If a temperature sensor fails, the microprocessor prevents rollers from overheating. [. . . ] Leave a minimum border of about 3mm(1/8"), to provide a proper edge seal. (Always allow lamination to cool down on a flat surface for about a minute before handling, to prevent permanent bending. If document is not laminated well, re-insert it and run it through a second time. ) 8. When continuously laminating, run the laminator at a lower setting because the internal machine temperature may be higher than the required temperatur, causing the document to bend or ripple. When finished laminating, turn off the machine. ***USEFUL INFORMATION*** * Sometimes, when continuously laminating, LED may begin blinking. If this happens, finish laminating the current document, then wait until the LED stops blinking, before inserting the next lamination. This could be fatal for the rollers due to the high internal temperature. EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 9 2. Press COLD It is ready when green LED blinking stops and buzzer rings. Insert document into Royal Sovereign cold laminating pouch as follows. **HOW TO ATTACH DOCUMENT ON COLD POUCH FILM** 1) Prepare cold pouch film. 2) Remove protective paper inside cold pouch. Back (Be careful not to allow the pouch to close and seal itself closed. If the pouch closes on itself and seals, you will not be able to the document to be laminated inside. ) Front 3) Place document squarely into the pouch, where the protecting paper was. Cold film's minimum border of about 3mm(1/8") is necessary to provide a proper edge seal. 4) Beware of dust while inserting document. Back 5) Feed pouch squarely into opening slot. When you are finished laminating, press the power button to turn off. ***USEFUL INFORMATION*** If it has recently been used for hot lamination, allow the rollers to be cooled down about 20~30 minutes. EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500 10 3. COLOR FOIL LAMINATING **Your laminator has ability to add color by using color foil to documents copied or printed by laser printer using toner. ** **PAPER CARRIER is required** 1. Position color foil where you want on the document and insert it into the paper carrier. When you are finished laminating, press the power button to turn machine off. ***USEFUL INFORMATION*** * The document, which has been foil laminated, is hot and easily bent. * When you do laminating several colors, use high temperature tape to hold color foils in place. * For high quality lamination, choose FUNC depending on thickness of material and PAPER CARRIER. [. . . ] Be sure that neckties, necklaces, long hair and loose clothing are kept away while the laminator is in operation. Make certain that the machine is connected to an adequate power source. This warranty does not cover damage or injury resulting from improper use or failure to follow the instruction manual provided. In no event will manufacturer, importer, warranty service center, its agents or assigns, be liable for losses, either direct or indirect, including but not limited to special, incidental, consequential, or punitive damages whatsoever incurred arising out of any breach of warranty by manufacturer, importer, warranty service center, their heirs or assigns or successors in interest. [. . . ]