User manual ROMMELSBACHER KM 3300

[. . . ] For damage arising from not intended use, the manufacturer does not assume liability. Technical data Only connect the appliance to an isolated ground receptacle installed according to regulations. Scope of supply Check the scope of supply for completeness as well as the soundness of the product and all components (see product description page 2) immediately after unpacking. Packing material Do not simply throw the packing material away but recycle it. [. . . ] The heating elements for a short time to ensure the proper functioning. heating-up the heating plates: · Heat up the heating plates without a pot at maximum setting for approx. This will give the After the appliance has cooled down, please clean the heating plates with a moist cloth. heating-up the oven: · Please clean all removable accessory parts in warm water with some dishwashing detergent. Prior to initial use, heat up the oven chamber for about 15 minutes with setting "upper and lower heat With circulating air" at maximum temperature (230 °C) in order to burn in the protective coating of the heating elements. After the appliance has cooled down, clean the interior oven with a moist cloth. NOTE: Please do not be bothered by the slight, harmless smoke and smell that will be generated for a short while when starting the appliance for the first time. Make sure the food touches neither the upper, nor the lower On the heating plates, only use cooking vessels of suitable Connecting the appliance to the power supply ATTENTION: Before connecting the appliance to the power supply, make sure that all rotary knobs are in position , , 0"!Each heating plate is equipped with a 4-step switch: Level 0: Off Level 1: Cooking small quantities, warming-up, keeping warm Level 2: Cooking larger quantities, roasting, stewing Level 3: Full power to start cooking Nominal consumption: level 1 level 2 level 3 The selection of the function for the large heating plate is done via the third rotary knob (D) from above. The selection of the function for the small heating plate is done via the fourth rotary knob (F) from above. Turn the rotary knob to position "0" once the cooking process is finished!Once both heating plates are switched on, the pilot lamp glows permanently. Insert the crumb tray into the oven · Before operating the oven, make sure, that the crumb tray is inserted below the lower heating element. Preparing the oven for use · Open the oven door (do not use the open door as storage place!Place the prepared food on the grill grid or roasting/baking tray and insert it in the provided insertion NOTE for using the grill grid: The special shape of the insertion levels in the front area prevents the grid from being pulled too far out of the appliance by mistake. Insert the grill grid with the grill bars upwards into one of the insertion levels. 10 cm, the , , removal lock" must be overcome by slightly lifting or angling the grill grid. Set the desired oven temperature by means of the upper rotary knob (A). Turn the rotary knob (A) to position "MIN" once the baking process is finished!Set the desired oven function by means of the second rotary knob (C) from above. Select the desired function by turning the knob to the left or to the right. The interior illumination of the oven lights up and the oven starts operation. [. . . ] Check the gasket all around for correct seating and readjust if necessary. Before cleaning, always unplug the appliance and let all parts cool down!Never immerse appliance, power cord and plug in water or clean them under running water!Wipe the casing, the oven chamber and the oven door with a moist cloth and wipe dry. [. . . ]