User manual ROMMELSBACHER CT 2020/IN

[. . . ] CT 3420/IN Control panel for left cooking zone Control panel for right cooking zone O for setting the "power level" mode 2 o zur Wahl des Modus , , Temperaturstufen" o for setting the "temperature level" mode O for changeover between "power level" and "Slider touch" area "1 ­ 10" for parameter setting Sensor "Lock" for key lock Display indicating o the set power level o the set temperature level o the remaining time of the set cooking time o the existing residual heat of the cooking zone o error codes in case of failure O , , Timer" für Betrieb mit Laufzeiteinstellung o "Timer" for operating with runtime setting O "Lock" for key lock 6 General notes for cooking with induction. Setting the operating time (timer) We are pleased you decided in favour of this superior induction cooking plate and thank you for your confidence. Its easy operation and wide range of applications will certainly fill you with enthusiasm as well. To make sure you can enjoy using this appliance for a long time, please read the following notes carefully and observe them. [. . . ] Once the temperature of the cooking zone has reached a value of more than 80 °C due to the waste heat emitted by the pot, the display shows "H" after switching off the appliance. As soon as the temperature has dropped below 80 °C or when the appliance is disconnected from the mains, the "H" in the display expires. Pot recognition Each cooking zone features a sensor, which recognizes whether there is a vessel on the cooking zone. Zone after switch-on, the display shows "E0" and an alternate warning signal sounds. If no pot is recognized within 60 seconds, the appliance switches automatically into the "Standby" mode. During operation, the display shows "E0" and an alternate warning signal sounds. If a pot is replaced within 60 seconds, the cooking process is continued at the last set level and a runtime continues, if it has been pre-set before. If no pot is recognized within 60 seconds, the appliance switches automatically to the "Standby" mode. Cooling fan After switch-on an inside fan starts working, which cools the interior components of the appliance in order to prevent the appliance from overheating. It is normal for the fan to continue running in "Standby" mode after a long operation time. operating time limitation · The operating time limitation will cause the cooktop to switch automatically in the "Standby" mode If the settings have not been changed for a period of 2 hours. After an automatic switch-off, the cooking plate can be switched on once again and the maximum operating time will be active again. In case the operating time (timer) is set for a period of more than 2 hours, this setting takes priority. Only after pulling the power plug or a cut-off from the power supply, there is a reset of the control to the default format with the figures "01" to "10". The values indicated below are reference values and apply to standard steel pots with 20 cm Ø. NOTE: A sensor in the centre of the cooking zone checks the temperature at the bottom of the cookware. The regulation will only function properly if the cookware covers this area. The cookware should have a flat and not too thick bottom to ensure a good heat transfer. The maximum tolerable temperature for the "power level" mode is 200 °C. Induction technology with its quick and direct heat transfer may cause a short-term overheating of small food quantities to be cooked. Thus, we recommend for heating small quantities to start with "power level" mode at a low power level (01 ­ 03), and to switch over to the desired temperature level after a few minutes. cooking large food quantities · In the upper performance range of the "temperature level" mode the power output is reduced. [. . . ] Never immerse the appliance into water and do not use steam jet appliances. If there is any dirt visible in the area of the ventilation slots, remove it from the outside by means of a The electronic control features several internal monitoring functions. If an error occurs, the power supply will be switched-off and an error code will appear on the display. Error code table: E0 Pot recognition: Each cooking zone features a sensor, which recognizes whether there is a vessel on the cooking zone. [. . . ]