User manual ROLLS RS79B

[. . . ] The obligation of Rolls Corporation under this warranty shall be limited to repair FEATURES: · 18 FM and 12 AM presets · Retains presets when power is off · Large LCD digital display · SCAN and SEEK functions · Standard 1 space EIA rack chassis · Headphone output, XLR outputs, and Signal Strength meter · Remote included INSPECTION 1. Unpack and Inspect the RS79b package Your RS79b was carefully packed at the factory in a protective carton. Nonetheless, be sure to examine the unit and the carton for any signs of damage that may have occurred during shipping. [. . . ] · Scan/Up: Increases the frequencies until a station strong enough to lock onto is reached. That station is played for approximately five seconds then scanning begins again. · Seek/Up: Increases the frequencies until a station strong enough to lock onto is reached. · Tune +: Increases the tuner frequency by . 1 MHz each time it is pressed. · Tune -: Decreases the tuner frequency by . 1 MHz each time it is pressed. LCD DISPLAY 5 A: Band indicator and number. NOTE: If the rear panel Frequency Select switch is set for 9kHz, the band will indicate MW 1 and MW2 instead of AM1 and AM2. If this light is out, the unit is operating in mono or the station is weak. D: Station frequency indicator E: Indicates whether the station frequency is AM (KHz), or FM (MHz) F: Preset number - 1 - 6. IMPORTANT NOTICE: IF THE POWER IS TURNED OFF BY THE REMOTE, THIS FRONT PANEL POWER SWITCH IS INOPERABLE UNTIL THE 2 REMOTE IS USED TO TURN THE POWER BACK ON. DESCRIPTION CONT. · AM reception may not be possible without the loop antenna attached. Even if an outdoor antenna is connected, keep this loop antenna in place. · Do not bring the power cord or speaker cords near the loop antenna. Multipath reflections FM waves, like light waves, travel in a straight direction unless reflected off objects in their path. Because of this, two sets of waves reach your antenna from the FM station; those that have traveled directly to the antenna, and those that have been reflected off buildings or mountains. [. . . ] To store that station in a preset (M1 - M6), press and hold the desired preset button until the CH # appears in the display. For example, once you've selected the desired station, to store that in preset M3, press and hold M3 until a CH 3 appears in the display. REMOTE OPERATION The included Infrared Remote provides a way to control the RS79b at a distance from the unit. [. . . ]