User manual ROLLS RPM26

[. . . ] LIMITED WARRANTY This product is warranted to the original consumer purchaser to be free from defects in materials and workmanship under normal installation, use and service for a period of one (1) year from the date of purchase as shown on the purchaser's receipt. The obligation of Rolls Corporation under this warranty shall be limited to repair or replacement (at our option), during the warranty period of any part which proves defective in material or workmanship under normal installation, use and service, provided the product is returned to Rolls Corporation, TRANSPORTATION CHARGES PREPAID. [. . . ] IN NO EVENT SHALL WE BE LIABLE FOR ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of special, incidental or consequential damages so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Rack Power Module RPM26 ROLLS CORPORATION SALT LAKE CITY, UTAH 5/06 OWNERS MANUAL INTRODUCTION Thank you for your purchase of the ROLLS RPM26 Rack Power Module. The RPM26 is a single rack space power distibution unit with eight rear-panel AC outlets, and an individually switched outlet on the front panel. The RPM26 features front-panel lighting in the form of brilliant white LED light. Because of the low voltage and high efficiency of these LEDs, they will likely never need replacing. An added feature is the inclusion of a front panel 12VDC BNC connector to power external or gooseneck type lights. Please read the following manual carefully to achieve the best results from this product. DESCRIPTION FRONT PANEL INSTALLATION Mount the RPM26 in a safe and sturdy rack. Connect the IEC power cable to the RPM26, and to a properly grounded AC outlet. [. . . ] 19" x 1. 75" x 5" (48 x 4. 5 x 12. 7) 5. 5 lbs (2. 5 kg) 100 - 220 VAC 50/60 HZ 10 VA: IEC Power Cord. INSTALLING A FUSE OTHER THAN THE RECOMMENDED RATING WILL DAMAGE THE UNIT. [. . . ]