User manual ROLLS RP93S

[. . . ] The RP93s will remain in Learn Mode after the default settings have been restored. RETURNING TO OPERATING MODE · To return to normal operation mode, press and hold the UP and DOWN buttons again (same as entering Learn Mode) for 5 seconds. Note: Any settings that have not been stored will be lost. PATCHWORK MIDI CONTROLLED AUDIO SWITCHER Thank you for your purchase of the RP93s Patchwork. This unit is designed as a MIDI Controllable audio and signal switcher. [. . . ] Program Numbers 100 - 128 will show a 00 - 28 along with a dot in the lower right of the tens digit to indicate the 100s. There is no program number 0, and 1 - 9 are displayed as single digits. DEVICE CONNECTION The FX loops have an input, 4 sets of sends and returns and an output. These may be used to control the presence of foot pedals, rack processors, other instruments, etc. These may also be used as a 4-way A/B box by connecting to the FX returns only and using the Main Out as the output. Since the RP93s is passive in its signal path (all switching is done with relays), the signal may go either way. This means the RP93s may also send a single signal to up to 4 different amplifiers. There is no change of interference or crosstalk because the switches are contact closure between the tip and sleeve of the 1/4" connectors. LEARN MODE Changes to the Switch and FX Loop settings for each Program Number settings are all made and stored in Learn Mode. Setting the MIDI Channel, and utilizing the RFX MIDI Test Mode are also done in Learn Mode. ENTERING LEARN MODE · The RP93 enters Learn Mode by pressing both UP and DOWN buttons simultaneously, and holding them down for approximately 5 seconds. Please note that in Learn Mode, no MIDI data is processed by the RP93s but data will continue to pass to the MIDI Through port. MODIFYING PRESETS · Pressing the UP and DOWN buttons will increment and decrement the display of the Program Number. As in Operating Mode, changing the Program Number with the UP and DOWN buttons will cause the stored switch and FX loop settings to be engaged. · Pressing a switch or LOOP button will alternate the on or off state of the associated switch or FX loop port. Changing the state of a port in this way does not affect the programmed setting for the displayed Program Number (until the STORE button is pressed). This will save the current setting of the switch and FX loop ports for the displayed Program Number. CHANGING THE MIDI CHANNEL In order for a Program Change commant to affect the switch and FX loop settings, the proper MIDI channel must be set. Press the DOWN button until 01 is displayed, then press once more - an oF appres in the display. To set a specific MIDI Channel, press the DOWN button until the desired channel is displayed. [. . . ] OPERATION Operating Mode The RP93s switch settings, once pre-programmed, are recalled via MIDI Program Change information and are then shown on the front panel display. The Program Change information must be sent on a MIDI Channel that matches the Channel of the RP93s. · The factory setting for the MIDI Channel Number is "omni" or channels 1 - 16. · The factory setting for all RP93s presets is all Switches and FX Loops OFF. [. . . ]