User manual ROLLS RD1024

[. . . ] LIMITED WARRANTY This product is warranted to the original consumer purchaser to be free from defects in materials and workmanship under normal installation, use and service for a period of one (1) year from the date of purchase as shown on the purchaser's receipt. The obligation of Rolls Corporation under this warranty shall be limited to repair or replacement (at our option), during the warranty period of any part which proves defective in material or workmanship under normal installation, use and service, provided the product is returned to Rolls Corporation, TRANSPORTATION CHARGES PREPAID. [. . . ] This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. RD1024 Digital Room Delay pwr SPECIFICATIONS Max. Input: Input Impedance: Output Impedance: Delay Range: Delay Resolution: Frequency Response: THD: Size: Weight: +16 dBV 10k balanced 50 balanced 4 - 1024 mSec as shipped 4 - 4096 mSec. with 4 update RAM chips 4 mS or 16mS in X 4 jumper postion 20Hz to 20kHz (+/-3 dB) 0. 3% 1. 75" H x 19" W x 5. 25" D. 7 lbs. ROLLS CORPORATION SALT LAKE CITY, UTAH 6/03 OWNERS MANUAL INTRODUCTION The RD1024 Digital Delay is used for speaker distance delay. With the extra memory it may even be used as part of a broadcast profanity delay. PLEASE NOTE: THIS MANUAL ASSUMES THE USER HAS A WORKING KNOWLEDGE OF BASIC AUDIO CONNECTION AND OPERATION PRINCIPLES. Selecting the Delay range The number of switches in the up position determines the delay time + 4 mS. Each switch to the left doubles the delay time and you add the number of switches up delay times to calculate the total delay then add 4 mS. The Switch positions are 4 8 16 32 64 128 256 512 mS Figuring the Time Delay Time delay in milliseconds (mS) is figured by adding the DIP switch OFF (Switch Up) positions then add 4. Example, If the 4 and 64 switches are up and the rest down then the delay time is 4 + 64 + 4 = 72 milliseconds of delay time. SCHEMATIC pwr INPUT LEVEL LEDs: Indicate the amount of input signal level, in decibels. DIP SWITCHES: Set the delay time JUMPER: for setting the maximum delay X 4 if extra RAM has been installed PWR: Indicates that the RD1024 has power and the power switch is in the ON position. [. . . ] Set the output level to drive the power amp or signal processing that follows the delay. Remember to run the input level as high as possible without clipping to achieve the highest signal to noise ratio. [. . . ]