User manual ROLAND RC-30

[. . . ] Please back them up as described in "Backing up to your computer" (p. * This device will enter Sleep mode (power conservation mode) when ten hours have elapsed since the last operation, or since the last audio input while in Stop mode. If you want to prevent the device from entering Sleep mode, hold down the left pedal while you turn on the power, and continue holding down it down for five seconds (p. The RC-30 is a pedal-type recorder that lets you record audio phrases from your guitar or vocal etc. [. . . ] Hold down the right pedal for two seconds or longer The current track will switch when you hold down the right pedal for two seconds or longer. Starting the two tracks simultaneously When you press the left pedal for a phrase that contains data, only the current track will start playback. If data exists in both track 1 and track 2, simultaneously pressing the track 1 and track 2 [SELECT] buttons while stopped (or using the right pedal to switch tracks several times) will cause the two buttons to light. If you start playback from this state, the two tracks will start simultaneously. To use the Memory Shift function, press the [ ] / [ ] buttons while a phrase is playing; the phrase memory number will blink, allowing you to select the next phrase (p. If you want the two tracks to stop simultaneously, press the right pedal twice in succession. Track 1 One shot Loop One shot Track 2 Loop One shot One shot * While phrase memory is being read, the PLAY (green) indicator will blink rapidly. Never turn off the power while the PLAY indicator is blinking rapidly. 5 seconds after you start recording, recording will continue until the phrase is at least approximately 1. However, in certain cases, such as when there is damage to the memory, it may not be possible to restore the data. * Unfortunately, it may be impossible to restore the contents of data that was stored in the unit's memory once it has been lost. For two seconds or longer, hold down the [SELECT] button of the track whose setting you want to change. Display Play Loop play Stop Stop immediately Explanation This is regular loop playback (default setting). Display Play Stop Explanation One-shot playback will play the phrase once from the beginning to the end, and then stop automatically. If the left pedal is pressed during playback of the phrase, the phrase starts playing from the beginning again (retrigger playback). Operation Display Explanation If you hold down the right pedal and press the left pedal, the phrase of the current track will be cleared. (Clear is temporary; phrases saved in phrase memory will not be deleted. * If you're clearing while stopped, the phrase will play if you press the left pedal first. The stop effect will be applied Fadewhen you press the right out and pedal. You can stop immediately the end by pressing the right pedal of the once again before the phrase phrase has stopped. "Auto recording" starts recording the moment you begin playing your guitar or play back your audio player. "Count-in" sounds the rhythm for one measure before recording starts. [. . . ] To switch the LOOP FX TYPE, hold down the B pedal of the FS-6 (FS-5U of stereo L side) while you press (within 2 seconds) the A pedal of the FS-6 (FS-5U of stereo R side). When ten hours have elapsed since the last operation or audio input, the RC-30 will enter sleep mode (power conservation mode; only the bypass sound will be output). To prevent battery consumption, turn off the power by removing the plug from the OUTPUT L jack. * The RC-30 will not enter sleep mode if there is a phrase that has not been saved. [. . . ]