User manual ROLAND GT-10

[. . . ] Owner's Manual Thank you, and congratulations on your choice of the BOSS GT-10. 201b Before using this unit, carefully read the sections entitled: "USING THE UNIT SAFELY" (p. These sections provide important information concerning the proper operation of the unit. Additionally, in order to feel assured that you have gained a good grasp of every feature provided by your new unit, Owner's manual should be read in its entirety. The manual should be saved and kept on hand as a convenient reference. 202 Copyright © 2008 BOSS CORPORATION All rights reserved. [. . . ] 0­100 * Be careful not to raise the Level setting too high. Bright Turns the bright setting on/off. The BRIGHT parameter setting is only partially available with some JC CLEAN, TW CLEAN, CRUNCH, or BG LEAD settings in Preamp Type. Off On Bright is not used. Provides for selection from three levels of distortion: LOW, MIDDLE, and HIGH. Distortion will successively increase for settings of LOW, MIDDLE and HIGH. * The sound of each Type is created on the basis that the Gain is set to MIDDLE. So, normally set it to MIDDLE. Gain Sw Low, Middle, High Solo Sw Chapter 8 Off, On Solo Sw is switched on to create the tone to one suitable for solos. Adjusts the volume level when the Solo Sw is ON. SoloLevel 0­100 SP Type (Speaker Type) Select the speaker type. This is the built-in speaker of the amp you selected with PREAMP TYPE. 99 Chapter 8 Parameters Guide Parameter/ Range 1x8" 1x10" 1x12" 2x12" 4x10" Explanation This is a compact open-back speaker cabinet with one 8-inch speaker. This is a general open-back speaker cabinet with two 12-inch speakers. This is an optimal speaker cabinet for a large enclosed amp with four 10-inch speakers. This is an optimal speaker cabinet for a large enclosed amp with four 12-inch speakers. This is a double stack of two cabinets, each with four 12-inch speakers. Custom speaker You can customize it however you like to match the sound you want. Custom Parameter/ Range Explanation CUSTOM AMP SETTING Setting available when Type is set to Custom. Type Selects the basic type of preamp. JC Clean TW Clean Crunch VO Drive BG Lead MS HiGain Modern Stk This is the sound of the Roland JC-120. Models the sound of the Channel 2 MODERN Mode on the MESA/Boogie DUAL Rectifier. This controls the input sound's low-frequency range and adjusts the amount of distortion in the low-frequency range. This controls the input sound's high-frequency range and adjusts the amount of distortion in the high-frequency range. Adjusts the preamp section's high-frequency tone. 4x12" 8x12" Custom Mic Type This setting selects the simulated mic type. Produces a sonic image close to that of listening to the sound directly from the speakers (on site). Bottom -50­+50 DYN421 Edge -50­+50 CND451 CND87 Bass Freq (Bass Frequency) -50­+50 Tre Freq (Treble Frequency) -50­+50 FLAT Mic Dis (Mic Distance) Simulates the distance between the mic and speaker. Provides conditions whereby the mic is directed more towards the speaker. PreampLow -50­+50 Preamp Hi (Preamp High) -50­+50 Mic Pos. Center 1­10cm Simulates the condition that the mic is set in the middle of the speaker cone. Simulates the condition that the mic is moved away from the center of the speaker cone. Adjusts the volume of the direct sound. Mic Level 0­100 0­100 DirectLev (Direct Level) 100 Chapter 8 Parameters Guide Parameter/ Range Explanation EQ (Equalizer) This adjusts the tone as a equalizer. [. . . ] 90 User Bank . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 User Patch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29, 43 User Phrase . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 112 User Quick Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]