User manual ROLAND EP-880

[. . . ] No part of this publication may be reproduced in any form without the written permission of ROLAND CORPORATION. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] For information about the tones that can be selected for the left hand section, refer to "Tone List" on page 207. NOTE This setting returns to the original value when you turn off the power. If you want to change the variation for the right-hand tone, cancel Split play and then re-select the tone. NOTE The selected left hand tone is remembered for each TONE SELECT button. Playing Different Tones with the Left and Right Hands (Split Play) Dividing the keyboard into right-hand and left-hand areas, then playing different sounds in each is called "Split play. You can change the location where the keyboard is divided (the split point) within the range of B1 through B6. NOTE When you continue holding the [SPLIT] button, the currently specified split point will be displayed. The key you pressed becomes the split point, and belongs to the left-hand section of the keyboard. You can also change the setting by pressing the [-] or [+] button while continuing to hold down the [SPLIT] button. If you hold down the [SPLIT] button and simultaneously press the [-] and [+] buttons, the setting will return to its original value (F#3). NOTE In Split play, the damper pedal will be applied only to the right-hand area of the keyboard. If you want the damper pedal to be applied to the left-hand area, refer to "Applying the Damper Pedal to the Left Keyboard Area" (p. The tone played on the right side is the tone in use before the [SPLIT] button is pressed, while the bass tone is played on the left side. The right hand will play the tone of the left button of Dual play, and the left hand will play a suitable match for the right-hand tone. While a song plays back, the metronome will sound at the tempo and time signature (Beat) of that song. Once again press the [METRONOME/COUNT IN] button, getting the button to go dark. The button flashes in red and green in time with the beat selected at that time. The button lights in red on the downbeats, and in green on weak beats. The volume of the metronome can be adjusted, with nine volume levels available. NOTE It is not possible to change the beat during song playback or recording. Continue to hold down the [METRONOME/COUNT IN] button, and press the [-] or [+] button to sound the metronome, and change the volume. NOTE When you hold down the [METRONOME/COUNT IN] button, the currently specified metronome volume will be displayed. [. . . ] When listening through headphones: Here, a different cause (such as resonance produced by the ep 880) would be suspect. " in the display indicates that there is performance material already recorded (p. This appears when a song with a pickup (a song that does not start on the first beat) is played back. The amount of performance information is too large, and further recording is not possible. [. . . ]