User manual ROLAND DP-990 ASSEMBLY

[. . . ] Assembling the DP-990 Make sure that another person is on hand to help with the assembly and setup. [. . . ] Retighten the screws loosened in Step 5. * Use the speaker cable with the ferrite core left attached to the cable. Connect the pedal cable to the Pedal jack. Attachment screw fig. st6. e Speaker cable (rear) Speaker box 2. fig. st1. e Secure the left side board to the speaker box with the attachment screws (M6 x 20 mm, in two places). Attachment screws Pedal Cable Side board left Stabilizer (left) Pedal Board 1 2 3 Stabilizer (right) Side board (right) 1: Attachment screw (M6 x 20 mm) x 8 2: Stabilizer screw (M4 x 16 mm) x 6 3: Cord clamp x 2 3. To stabilize the pedals Temporarily loosen the screws that fasten the pedal board. Step on the pedal, and after verifying that the pedal is in firm contact with the floor, re-tighten the attachment screws firmly. Align the protruding screws (one each at right and left) on the bottom of the piano with the openings in the metal fittings on the side board, then slide the piano forward until the screws are held in place. Place the keyboard so that it is centered, both front to back and left to right. Rear Front 11. As necessary, affix cord clamps as shown in the diagram to fasten the pedal cable. fig. st9. e L Raise the entire assembly. When standing the assembled unit up, grasp near the speaker box, and gently raise the assembly. Cord Clamps Speaker Cable Power Cord Pedal Cable fig. st4 The speaker box can also be installed so that it faces toward the rear instead of toward the front. Having the speaker box face out the rear of the instrument allows the speakers to be directed toward listeners when the back of the instrument faces the audience. fig. stsp. e * Normal direction Front Rear When facing to the rear Front Rear When Moving the Instrument Disconnect the power cord and cables from the DP-990. [. . . ] 7. 8 4. 7 · · 8. · DP-990 © [. . . ]