User manual ROLAND CSQ-600

[. . . ] Be very careful, when you assemble and move the piano, to make sure that you do not drop it on your hands or feet. [. . . ] You will also need to have a Phillips screwdriver. fig. st900parts. e Assembly Procedure · At first, assemble the entire unit in a temporary fashion, without really tightening the screws. Then, after checking the overall alignment of the boards (and gently shifting certain parts where necessary), go around and tightly fasten each of the screws. · Be careful when assembling the CSQ-600, so as to avoid scratching the side boards. When securing the screws, lay the entire unit sideways with the rear side of the CSQ-600 at the bottom. CSQ-600 Side board left 1. Secure the Pedal Board to the side boards with the attachment screws (in two places). Retighten the screws loosened in Step 5. fig. st6. e fig. st9. e Cord Clamps Pedal Cord Attachment screws To stabilize the pedals Temporarily loosen the screws that fasten the pedal board. Step on the pedal, and after verifying that the pedal is in firm contact with the floor, re-tighten the screws firmly. When Moving the Instrument Disconnect the AC cord and cables from the CSQ-600. Then lift the piano while keeping it level, and move it with care, so that you do not drop it on your feet, or get your hands caught. Check the stability of the pedal, and make adjustments as necessary. 7. [. . . ] Lay the CSQ-600's keyboard onto the stand and secure it with the screws (in four places). Place the keyboard so that it is centered, both front to back and left to right. [. . . ]