User manual ROLAND CR-78

[. . . ] Should you remove screws, cord clamps, or stabilizer, make sure to put them in a safe place out of children's reach, so there is no chance of them being swallowed accidentally. 5. Put the Pedal Board on the stabilizer. When putting the Pedal Board on the stabilizer, first loosen the attachment screws securing the speaker box to the side boards. Loosen the screws (in four places). 9. fig. st5. e fig. st8. e Connect the speaker cable extending from the rear of the speaker box to the CR-78's speaker connector. [. . . ] When putting the Pedal Board on the stabilizer, first loosen the attachment screws securing the speaker box to the side boards. Loosen the screws (in four places). 9. fig. st5. e fig. st8. e Connect the speaker cable extending from the rear of the speaker box to the CR-78's speaker connector. Press the speaker cable completely into the connector so that it is securely fastened. CR-78 Rear Putting the Pedal Board (a lateral view) Pedal Board Check the Parts Before you begin assembling the CR-78, check that all the parts were supplied. You will also need to have a Phillips screwdriver. fig. st900parts. e 1. Secure the right side board to the speaker box with the attachment screws (M6 x 20 mm, in two places). Attach so that the speaker cable at the rear of the speaker box is directed to the left. Side board right Speaker box Front Speaker Connecter Speaker cable Clip Portion Ferrite Core Pedal Board Pedal Cable Metal Parts Hold and insert the cable so that the clip portion extends into the stand and is securely connected. Side board (left) CR-78 R Rear 6. Secure the Pedal Board to the side boards with the attachment screws (M6 x 20 mm, in two places). Then lift the piano while keeping it level, and move it with care, so that you do not drop it on your feet, or get your hands caught. Check the stability of the pedal, and make adjustments as necessary. 4. fig. st3. e Please don't get your fingers pinched Set the stabilizer in the holes in the side boards (M4 x 16 mm, in six places). 8 7 Attachment Screw Speaker box Speaker box When Disassembling Disassemble the unit by carrying out assembly Steps 111 in reverse order. Assembly Procedure · At first, assemble the entire unit in a temporary fashion, without really tightening the screws. Then, after checking the overall alignment of the boards (and gently shifting certain parts where necessary), go around and tightly fasten each of the screws. · Be careful when assembling the CR-78, so as to avoid scratching the parts. Right Rear Front (Keyboard) When Changing the Orientation of the Speaker Box Be sure to completely disassemble the unit, change the speaker box orientation, then reassemble it. Left Stabilizer screws Take care not to attach the left and right stabilizer to the wrong sides. 8. fig. st7. e Fasten the piano to the stand with the attachment screw (M6 x 20 mm) (one each for the right and left). Copyright © 2007 ROLAND CORPORATION * 4 0 7 8 2 7 3 4 - 0 1 * CR-78 All rights reserved. [. . . ] · Be careful when assembling the CR-78, so as to avoid scratching the parts. Right Rear Front (Keyboard) When Changing the Orientation of the Speaker Box Be sure to completely disassemble the unit, change the speaker box orientation, then reassemble it. Left Stabilizer screws Take care not to attach the left and right stabilizer to the wrong sides. 8. fig. st7. e Fasten the piano to the stand with the attachment screw (M6 x 20 mm) (one each for the right and left). Copyright © 2007 ROLAND CORPORATION * 4 0 7 8 2 7 3 4 - 0 1 * CR-78 All rights reserved. [. . . ]