User manual ROLAND C-380

[. . . ] IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION: RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS. IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS WARNING - When using electric products, basic precautions should always be followed, including the following: 1. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] 56). · · · · You can mute (silence) the performance of a specific division (p. You can listen to the performance of a specific division as a guide tone (p. When a song is played back, the registrations that were used at the time it was recorded will automatically be called up. If you wish to preserve the current overall status of the organ, make sure to save your settings to a memory piston beforehand (p. Then, using the [Select/Menu] knob, select "Play Mode. " Next, turn the [Value/Exit Menu] knob to change the setting to "CHAIN. " Setting OFF CHAIN Explanation Play back only the selected song Consecutively play back all the songs on the selected media Selecting and Playing Back a Song fig. rec-play-2. eps 1. If you want to play back a song from USB memory, connect your USB memory to the external memory connector (p. From the main screen, press the [STOP] piston to access the "Song Recorder" screen. fig. LCD034. eps 3. Turn the [Select/Menu] knob to select the media type field in the upper right. fig. LCD033. eps 50 Practicing Along with a Preset Song or Performance Data 4. Turn the [Value/Exit Menu] knob to select the media on which the song is stored. Setting USB INT PRE Explanation Play back song data from USB memory Play back song data from internal memory Play back built-in preset song (demo song) * For more information about the built-in preset songs, refer to "List of Preset Song/Demo Song" (p. Turn the [Value/EXIT MENU] knob to choose the song that you want to play back. If a screen like the following appears If internal memory contains performance data that has not been saved, the following message will appear when you attempt to select a saved song. fig. LCD952. eps · If you want to discard the performance data without saving it, press the [SET] piston. · If you don't want to erase the performance data, press the [Value/Exit Menu] knob. Save the performance data as described in "Saving a Recorded Song" (p. Press the [PLAY/PAUSE] piston to play back the song data. · "PU" is shown as the measure number if the song starts on a weak beat. Playback will resume from the same location when you press the [PLAY/PAUSE] piston once again. 8. To stop playback, press the [STOP] piston. 51 Practicing Along with a Preset Song or Performance Data Muting a Specific Division During Playback When playing back a song, you can individually mute (silence) the performances of the MAN II division (upper keyboard), MAN I division (lower keyboard), and PEDAL division (pedalboard). 1. From the main screen, press the [STOP] piston to access the "Song Recorder" screen. Turn the [Select/Menu] knob to select "Division Mute. " fig. LCD035. eps 4. Press the [Select/Menu] knob to access the "Division Mute" screen. Turn the [Select/Menu] knob to select the division that you want to mute. Turn the [Value/EXIT MENU] knob to change the setting from "PLAY" to "MUTE. " fig. LCD036. eps 7. Press the [PLAY/PAUSE] piston to play back the song. Only the divisions that are set to "PLAY" will be heard; divisions for which you selected "MUTE" will be muted. [. . . ] 77 Voice Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65 VOICING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 73 Volume Expression Pedal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42 External Audio Device . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]